BRENNEN

Industries / Industrial equipment and services / Industrial services

Rope access

Rope access is the work of reaching jobs on tall structures, cliffs and deep or awkward spaces by hanging from two ropes, one to work from and one as a backup, instead of building a scaffold or bringing in a lift.

1986

CAN, a British contractor, was formed and began using ropes and harnesses for maintenance on offshore oil and gas platforms; the trade journal Offshore Engineer says it "pioneered industrial rope access techniques offshore" that year.

oedigital.com

31

Milestones achieved across 6 domains.

6

To watch for: announced, not yet confirmed outside.

12

Open deliverables. Nobody has shipped them.

In one minute

Where it started

People were lowered on ropes to work long before the trade had a name: at Hoover Dam in the 1930s, "high scalers" in bosun's chairs stripped loose rock from the canyon walls. The modern method came from caving and climbing. By one practitioner's account, French mountain guides were hired in the 1970s to make cliffs above roads safe, British firms abseiled on bridges and buildings by the early 1980s, and from 1986 the work moved onto North Sea oil platforms. In 1987 six companies formed the Industrial Rope Access Trade Association (IRATA) in Britain.

Where it stands

The core rule, two separately anchored ropes so that no single failure causes a fall, has been European law since 2001, and the work now has its own standards from CEN (2006), ISO (2003 and 2012) and the American Society of Safety Professionals (2021). IRATA reports more than 22 million hours a year on ropes by its member companies' technicians, and SPRAT has certified technicians in North America since 2001. Engineers on ropes inspect façades under city laws, bridges under the US arm's-length rule and monuments after earthquakes. Drones now do some of the looking, but New York found in 2021 that photographs cannot replace touching the wall, and in a 2026 university trial drone pilots found about half the defects on a test wall.

What is open

Much of what keeps a technician safe has never been measured: how long edge protectors last on a sharp edge, whether backup devices lock when a falling person grips them, how fast rigging skills fade after an assessment and how reliably people find hollow tiles by tapping. Nobody keeps a register of people left hanging in harnesses, and nobody has compared drone surveys with hands-on findings on the same real buildings. Each of these can be done on a bench at ground level or from existing records, with test rigs, low-cost robot arms and AI models that answer fixed questions about documents and images.

Domains

AchievedWatch forOpen

Advances to build with

1 research note

Open in rope access

3 of 12 open deliverables

Open · Rigging and anchors

Bench-test edge protectors

A ground-level test bench that holds a rope access rope at a set tension over an edge sample (a 90° steel angle, a cut edge of toughened glass and a concrete edge) while a motor slides the edge back and forth across the rope, as a technician moves sideways below. It counts the cycles until each commercial edge protector is cut through and then until the rope's sheath is cut, and the results are published as a table.

Built with what exists

a universal testing machine of the kind university materials laboratories have (Instron and ZwickRoell make them) or a steel frame with a screw actuator; a load cell; a geared motor on a linear slide; an Arduino or Raspberry Pi to log tension and count cycles; a phone camera; EN 1891 low-stretch rope; ten edge protectors bought from rope access suppliers. Everything runs on a bench, behind a guard, with nobody on a rope.

Credit · unclaimed

Open · Inspection work

Count what drones miss

A public comparison, for real façades in New York City, of what a drone survey showed and what the hands-on drops found on the same walls, built from inspection records that already exist. For each façade, every unsafe or SWARMP condition (DOB's "safe with a repair and maintenance program", meaning safe now but needing repair within five years) found by hand is listed, and two reviewers mark whether it can be seen in the drone images. No one flies or climbs for the study.

Built with what exists

Paired drone and close-up records from Qualified Exterior Wall Inspectors (the licensed engineers and architects who file New York's façade reports) who used both in the current cycle; DOB's public list of façade filings on NYC Open Data, which names each filing's inspector, wall material and status; OpenDroneMap, open-source software that stitches drone photos into a measured image of a whole façade; a model that answers fixed yes-or-no questions about each image, such as Google's Gemini Decision 1 (Note: "A thousand questions, one pass"), to pre-sort photos before people check them.

Credit · unclaimed

Open · Repair and coating work

Break ropes that met grit

A published laboratory test of how much strength rope access ropes lose to the dirt that coating work brings: blasting grit (garnet, slag or steel grit) worked into the rope, and drips of epoxy or zinc primer cured on it. Samples are run through a descender (the friction device a technician lowers on) on a bench rig at ground level and then pulled to failure in a tensile machine, beside clean controls.

Built with what exists

One production lot of low-stretch kernmantle rope of the kind used for rope access (EN 1891 type A); abrasives from a blasting supplier; two-part epoxy and zinc-rich primer; a motor-driven bench rig that pulls rope through a descender at a fixed load; a tensile testing machine at a university or accredited laboratory.

Credit · unclaimed

Where it sits