BRENNEN

Industries / Construction and property / Commercial and residential construction / Electrical contracting / Solar installation

Solar farms

This work builds power plants of thousands to millions of panels on open land, on farmland and on water: clearing the site, driving the posts, setting up racks or sun-following trackers, and placing the panels.

7

Milestones achieved, from 1982 to 2024.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1982

    A megawatt on trackers

    On 18 November 1982 ARCO Solar, the solar arm of the oil company Atlantic Richfield, began running a 1 MW plant beside Southern California Edison's Lugo substation at Hesperia, California: 108 computer-controlled trackers that turned 256 panels each to follow the sun, on 20 acres. A year later it connected a far larger plant on the Carrisa Plain in San Luis Obispo County, 4.5 MW at first, which its builder Fluor calls the world's first large-scale solar power plant. The Center for Land Use Interpretation (CLUI) says Carrisa's panels lost output from a design flaw; the plant was shut in 1994 or 1995, by different accounts, and its panels were resold.

    LessonPanels not yet proven in the field can sink a plant on a good site; the same land later held the largest solar plant in the US, by CLUI's account.

    osti.govclui.orgfluor.com

    Credit

    ARCO Solar (R. E. L. Tolbert and J. C. Arnett, who described both plants); Southern California Edison; Fluor

  2. 2016

    Crops and panels share fields

    In 1981 Adolf Goetzberger and Armin Zastrow of Fraunhofer ISE proposed growing crops under raised panels, in an article titled "Kartoffeln unter dem Kollektor" (potatoes under the collector). In 2016 a German research group built a 194 kW pilot on a third of a hectare of arable land at Hofgemeinschaft Heggelbach, a farm near Lake Constance: 720 panels that take light on both faces, set 5 m up. By the project's own measure, using the same land for crops and power raised its total output by 60 to 86% against splitting it between the two. Fraunhofer counts such "agrivoltaic" plants worldwide growing from about 5 MW in 2012 to at least 14 GW in 2021, and Germany defined the method in standard DIN SPEC 91434 in 2021.

    ise.fraunhofer.de

    Credit

    Fraunhofer ISE; University of Hohenheim; BayWa r.e.; Hofgemeinschaft Heggelbach

  3. 2017

    Hurricanes test the racks

    Hurricanes Irma and Maria brought sustained winds of more than 180 mph to the Caribbean. Some ground-mounted arrays in the British Virgin Islands, Turks and Caicos, Puerto Rico and St. Eustatius produced power the next day; others in Puerto Rico, the US Virgin Islands and Barbuda were wrecked. Engineering teams sent by RMI found the failures came from clamps over panel edges, racks not designed for wind or for sideways load, small or loose bolts, joints that shook loose and self-tapping screws. Survivors had two-post foundations, panels bolted through their frames, side bracing, lock nuts and structural calculations checked by an owner's engineer.

    LessonSmall parts decided survival; an engineer at the US National Laboratory of the Rockies (formerly NREL) later wrote that storm damage depends more on a system's features than on the size of the storm.

    rmi.orgosti.gov

    Credit

    RMI; Clinton Climate Initiative

  4. 2019

    A floating array tears apart

    Typhoon Faxai struck Chiba, Japan, on 9 September 2019 with winds of up to 207 km/h. It tore loose and piled up panels of the 13.7 MW floating plant on the Yamakura Dam reservoir, 50,904 Kyocera panels on 44 acres of water, and a fire broke out in about 50 of them. Japan's Ministry of Economy, Trade and Industry (METI) concluded in April 2020 that seven of the 420 anchors came loose at the central southern edge, after which the resin bolts linking the floats failed one after another and the array ripped into three parts. The plant was rebuilt as smaller square islands.

    LessonIn one large floating island a few failed anchors pass their load along until the raft tears, so smaller islands limit how far a failure spreads.

    pv-magazine.compv-magazine.com

    Credit

    Chiba Prefecture's Public Enterprises Agency (owner); Kyocera TCL Solar; Ciel & Terre (floats); METI (investigation)

  5. 2022

    Mud fines at solar farms

    Building a solar farm means clearing and grading large areas of land, and rain can wash the bare soil into streams. On 13 November 2022 the US Environmental Protection Agency (EPA) and Justice Department settled cases against the owners of four solar farm construction sites in Alabama, Idaho and Illinois, all built by one common contractor, for $1.34 million in civil penalties. The complaints said the owners failed to design, install and maintain stormwater controls, failed to inspect their sites regularly with qualified staff and failed to report problems; at the Alabama and Idaho sites, excess sediment reached nearby waters.

    LessonThe owner of a solar farm answers for its construction site, and erosion control is part of building one.

    epa.gov

    Credit

    US EPA; US Department of Justice; the states of Alabama and Illinois

  6. 2024

    Midong reaches 3.5 GW

    In June 2024 China Green Development Group switched on the 3.5 GW Midong plant in the desert near Urumqi, Xinjiang, which pv magazine called the largest solar plant in the world. By the owner's figures it uses more than 5.26 million panels of 650 W each on 1.23 million posts, five 220 kV substations and more than 208 km of power lines, and cost CNY 15.45 billion (USD 2.13 billion). China Construction Eighth Engineering Division and PowerChina built it in stages.

    pv-magazine.compowermag.com

    Credit

    China Green Development Group; China Construction Eighth Engineering Division; PowerChina

  7. 2024

    The next weak link

    Hurricane Beryl, the earliest Category 5 hurricane on record in the North Atlantic, crossed the Grenadines in July 2024. On the island of Mayreau a 100 kW ground-mounted array built to 180 mph wind standards with RMI's 2018 practices kept every post, purlin and bolt in place, yet about 70% of its panels failed at the holes in their frames where they were bolted down, from repeated flexing. RMI's Solar Under Storm III (June 2025) adds this failure to its list and advises against trackers in zones that face Category 3 or stronger winds.

    LessonFixing the weakest part moves failure to the next one, so tests must go past the last fix.

    rmi.org

    Credit

    RMI; Azimuth Advisory Services; Clinton Climate Initiative

Watch for

  1. A factory beside the field

    Terabase Energy's Terafab sets up an assembly line on the building site, where robots fix panels onto the steel tubes of trackers and rovers carry the finished pieces to their posts. The company says one line works on a two-minute cycle, which run day and night would install more than 20 MW a week, about 1 GW a year; its first version was used on five projects, and a US Department of Energy account says a 2022 Texas demonstration built 10 MW of a 400 MW site. In November 2026 Matrix Renewables said it is using the second version on part of its 457 MW Tormes Solar project in Navarro County, Texas, built by Solv Energy.

    Achieved whenMatrix, Solv or another outside party publishes the megawatts per week actually installed at Tormes and the defect rate found by inspection.

    solarpowerworldonline.compv-magazine.comenergy.gov

    Claimed by

    Terabase Energy, March 2026; Matrix Renewables, November 2026

Open

  1. 01

    Storm damage by mounting type

    A public table of every US mainland utility-scale solar plant that sat inside a hurricane's hurricane-force winds since 2017, coded by how it is mounted (fixed tilt or tracker) and by the damage seen in satellite images before and after the storm.

    The brief
    Credit · unclaimed
  2. 02

    Erosion watched from orbit

    A monthly satellite check of bare soil at US solar farms under construction, flagging sites where cleared ground stays bare through the rainy season or spreads toward streams, scored against what stormwater inspectors recorded at the same sites.

    The brief
    Credit · unclaimed

Open 01 · the brief

Storm damage by mounting type

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public table of every US mainland utility-scale solar plant that sat inside a hurricane's hurricane-force winds since 2017, coded by how it is mounted (fixed tilt or tracker) and by the damage seen in satellite images before and after the storm.

Why it is still open

RMI's 2025 guidance advises against trackers in zones facing Category 3 or stronger winds, while trackers are now the usual choice for new US plants. Kirsten Perry, Dirk Jordan and Quyen Nguyen of the National Laboratory of the Rockies (formerly NREL) used satellite images to count damage at more than 1,500 systems in Puerto Rico and the US Virgin Islands after Irma and Maria, about 17% of them damaged, and found only a weak link between gust speed and damage, with installation practices playing a heavy role; their open dataset covers those islands and a 2023 Austin hailstorm, not mainland plants, and does not compare trackers with fixed racks. A 2026 framework by Bonnie Powell, James Elsworth and Dirk Jordan says more data are needed to build damage curves for each system feature.

rmi.orgresearch-hub.nlr.govosti.govosti.gov

Built with what exists

The US National Hurricane Center's best-track and wind-radius files; EIA Form 860, whose solar schedule gives each plant's location and tracking type; Sentinel-2 satellite images (10 m per pixel) and, where licensed, finer commercial images; Perry and colleagues' labeled images to train or check a damage model; a vision model that answers fixed yes-or-no damage questions per image (see the Note "A thousand questions, one pass"); QGIS and Python.

  1. First step

    List the EIA-860 plants inside Hurricane Ian's hurricane-force winds in Florida in 2022 and record each one's tracking type.

  2. Done looks like

    Every EIA-listed plant within the hurricane-force wind radii of US mainland landfalling hurricanes from 2017 to 2025 coded, with damage rates by mounting type and plant counts published along with the images and code.

Open 02 · the brief

Erosion watched from orbit

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A monthly satellite check of bare soil at US solar farms under construction, flagging sites where cleared ground stays bare through the rainy season or spreads toward streams, scored against what stormwater inspectors recorded at the same sites.

Why it is still open

The EPA's 2022 cases rested on what inspectors found on site visits. In 2024 Profile Products, a maker of erosion-control products, modeled more than 13,900 current and planned US solar sites from soil, slope and climate data and rated 29% of them, more than 294,000 acres, at risk of increased erosion; that is a risk model, not a measurement. This research found no study that tracks solar construction sites from satellite images and checks the result against inspection records.

epa.govinformedinfrastructure.com

Built with what exists

Sentinel-2 images (10 m per pixel, a new pass every few days); EIA Form 860M for plant locations and planned start dates; EPA's ECHO enforcement database and state construction stormwater records; a bare-soil index computed in Google Earth Engine or Python; QGIS.

  1. First step

    Take the four sites in the EPA's 2022 settlements and plot their bare-soil area month by month through construction.

  2. Done looks like

    100 solar farms built between 2020 and 2025 in at least three states, each with a monthly bare-soil series through construction, and the flag's agreement with recorded inspection findings published with the code.