BRENNEN

Industries / Energy, water and waste / Water and wastewater

Pipes and leaks

Carrying treated water under pressure from the plant to every tap, through large pipes under the streets (mains) and smaller service lines into each building, and finding and fixing the leaks along the way.

7

Milestones achieved, from 1672 to 2026.

2

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1672

    Cast iron holds the pressure

    The palace of Versailles says the first cast iron pipes in France were made there in 1672. Earlier pipes of hollowed tree trunks, copper and earthenware could not take high pressure, and lead pipes cracked often; cast iron came into general use under Louis XIV and later replaced the palace's lead pipes.

    en.chateauversailles.fren.chateauversailles.fr

    Credit

    the royal water works at Versailles under Louis XIV; the sources name no pipe maker

  2. 1986

    US bans lead pipe

    Amendments to the US Safe Drinking Water Act banned lead pipe, solder and flux in public water systems and plumbing installed after June 1986, though "lead free" still allowed up to 8% lead in pipes. In 2011 Congress cut the limit for pipes, fittings and fixtures to a weighted average of 0.25%.

    LessonA ban stops new lead from going in but leaves the old lead in the ground.

    epa.gov

    Credit

    US Congress; US EPA

  3. 1991

    Testing water at the tap

    EPA's Lead and Copper Rule made utilities sample water at customers' taps, because lead enters the water inside pipes and testing at the plant misses it. If more than 10% of samples exceed 15 parts per billion (ppb) of lead or 1.3 parts per million of copper, the utility must make its water less corrosive, tell the public, and may have to replace lead service lines.

    epa.gov

    Credit

    US EPA

  4. 2006

    Counting the water that vanishes

    A World Bank paper estimated that cities lose about 48.6 billion cubic meters of water a year as "non-revenue water": 32.7 billion to leaks and 15.9 billion delivered but never billed. It pushed utilities to use the International Water Association's water balance, an audit that splits the water entering a network into billed, leaked and unaccounted-for parts.

    LessonLater counts came out far higher; in 2018 Liemberger and Alan Wyatt put losses at 126 billion cubic meters a year, worth US$39 billion, and said earlier estimates were two to three times too low.

    documents1.worldbank.orgthesourcemagazine.org

    Credit

    Bill Kingdom, Roland Liemberger and Philippe Marin (World Bank); the IWA for the method

  5. 2014

    Flint's corrosion failure

    In April 2014 Flint, Michigan, stopped buying water from Detroit and switched to its own plant, which did not use corrosion control, a treatment that keeps pipes from releasing metal into the water. In September 2015 an independent Virginia Tech team reported that the 90th-percentile lead level in 252 homes was 25 ppb, above EPA's 15 ppb action level; Flint switched back on 16 October 2015, and the US Centers for Disease Control and Prevention found the share of young children with high blood lead rose from 3.1% to 5.0% early in the switch.

    LessonChanging a city's water without corrosion control can turn old lead pipes into a public health emergency.

    cdc.govflintwaterstudy.org

    Credit

    Marc Edwards, Amy Pruden and Joseph Falkinham (Virginia Tech Flint Water Study); CDC

  6. 2024

    US orders lead lines out

    EPA's Lead and Copper Rule Improvements, issued on 8 October 2024, require US water systems to find and replace their lead service lines within 10 years.

    epa.gov

    Credit

    US EPA

  7. 2026

    Satellites screen a whole state

    New Mexico's Environment Department pays for satellite leak screening for local utilities: a radar satellite senses moisture up to about 3 meters (10 feet) underground, software separates treated water from rain or groundwater, and inspectors check each flagged spot on foot. After a pilot in five communities the state gave ASTERRA a four-year statewide contract in January 2026, and the program reported 216 leaks across 28 utilities in its first statewide year.

    govtech.comwaterworld.com

    Credit

    ASTERRA (satellite analysis); New Mexico Environment Department (program)

Watch for

  1. Satellite leak hunt in London

    Thames Water says a project with Origin Tech, which uses satellite data and AI to find underground leaks, is expected to save more than 100 million liters of water a day. The project began in March 2026 and is set to run for 13 months at first.

    Achieved whenThames Water's reported leakage falls by about that amount, and the regulator or an independent auditor ties the fall to this project.

    thameswater.co.uk

    Claimed by

    Thames Water and Origin Tech, March 2026

  2. Model-cleared lead lines questioned

    A single-author preprint, not peer reviewed, audits New York State's service-line records and estimates that 1,150 to 1,450 lead lines may sit among addresses that predictive models marked as not lead; in New York City, all 43,215 addresses classified by a model are recorded as non-lead.

    Achieved whena utility or the state physically checks a random sample of model-cleared addresses and confirms or refutes the estimate, or the paper passes peer review.

    arxiv.org

    Claimed by

    Muhammad Sarmad Sohail, August 2026

Open

  1. 01

    Score the satellite leak flags

    A standard way to score satellite leak detection, and the first public score for one program: how many flagged spots had a leak, how many were dry, and what share of all the leaks found in the same period the satellite had flagged.

    The brief
    Credit · unclaimed
  2. 02

    Check the lead-line models

    A field check of the models that cleared addresses of lead: a random sample of addresses a model marked as not lead, each checked by looking at the pipe where it enters the building.

    The brief
    Credit · unclaimed

Open 01 · the brief

Score the satellite leak flags

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A standard way to score satellite leak detection, and the first public score for one program: how many flagged spots had a leak, how many were dry, and what share of all the leaks found in the same period the satellite had flagged.

Why it is still open

Reports on New Mexico's statewide program count leaks found, 216 across 28 utilities, but not how many flagged spots were dry or how many leaks the satellite missed.

govtech.comwaterworld.com

Built with what exists

Public records requests to the New Mexico Environment Department and participating utilities for flag lists, field-check results and repair orders; Python; an open map.

  1. First step

    Request the first year's flag lists and field-check outcomes from the Environment Department.

  2. Done looks like

    A published score for at least five utilities in the program, with false alarms and misses counted, and the scoring method released so other programs can be scored the same way.

Open 02 · the brief

Check the lead-line models

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A field check of the models that cleared addresses of lead: a random sample of addresses a model marked as not lead, each checked by looking at the pipe where it enters the building.

Why it is still open

The New York preprint (see Watch for) found that almost no address in the state's records has both a model prediction and a physical check, so the models' accuracy is mostly unknown. North Carolina's October 2026 guidance requires random physical checks before a model can be used.

arxiv.orgdeq.nc.gov

Built with what exists

New York State's published service-line inventory; EPA's Protect Your Tap guide, which shows a homeowner how to check a pipe with a penny or key and a magnet; phone photos; a vision-language model that sorts the photos for a person to confirm (see the Note "Seven more flagged").

  1. First step

    Pick a utility with many model-cleared addresses in the state data, and draft a consent form and a photo guide based on EPA's.

    epa.gov

  2. Done looks like

    300 model-cleared addresses in one utility checked with the owners' consent, results published without personal details, and the share found to be lead compared with the preprint's estimate.