BRENNEN

Industries / Construction and property / Commercial and residential construction / Pool construction

Water chemistry and service

Keeping pool water safe and clear: dosing and testing the chemicals that kill germs, keeping the water in balance, and the weekly cleaning done by service technicians and by machines.

7

Milestones achieved, from 1910 to 2024.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1910

    Chlorine sterilizes a pool

    Before chlorine, most pools were filtered and their water was changed often. In 1910 John Wymond Miller Bunker, a graduate student at Brown University in Providence, Rhode Island, dragged a cheesecloth bag of bleaching powder ("hypochlorite of lime") through the 70,000-gallon Colgate Hoyt Pool to a chlorine level of 0.5 ppm (parts per million); surface bacteria counts fell from 500 to 30 per cubic centimeter in 15 minutes. The chemist Kevin Olsen calls it, "as near as the author can determine", the first attempt to sterilize a US pool with chlorine. By 1923 seven states regulated pool sterilization, though pools were still drained and refilled from time to time through the 1920s.

    ideals.illinois.edumsuweb.montclair.edu

    Credit

    John Wymond Miller Bunker, Brown University

  2. 1929

    A company to service pools

    In the 1920s nobody made pumps or filters for home pools: contractors adapted pumps from boats and filters from chemical plants and dry cleaners. John Mudge, a former chemical engineer, founded the first specialty pool supply company in 1925 and, in 1929, the first pool maintenance company, Chemtech, in California, Olsen writes, citing Thomas van Leeuwen's history of the private pool, The Springboard in the Pond.

    ideals.illinois.edu

    Credit

    John Mudge

  3. 1974

    Cleaners run on the pump

    An automatic pool cleaner uses the suction of the pool's own filter pump to crawl across the floor and vacuum it, so nobody has to push a brush. The Pool Bug, designed in the late 1960s by the Johannesburg inventor John Raubenheimer, reached the market in 1972 but was unreliable at first. Ferdinand Chauvier, a hydraulics engineer, sold the first Kreepy Krauly from his home workshop in Springs, South Africa, in 1974; Mike Bruton, writing in IOL, calls it the first commercially successful pool vacuum cleaner, and says it was cleaning more than a million pools when Chauvier died in 1985. Maytronics says it launched the first robotic pool cleaner, which carries its own motor and filter, as the Dolphin in 1983 in Kibbutz Yizre'el, Israel; that "first" is the company's own.

    iol.co.zaewn.co.zamaytronics.com

    Credit

    John Raubenheimer; Ferdinand Chauvier; Maytronics

  4. 2006

    WHO sets pool limits

    The World Health Organization's guidelines for swimming pools recommend that each country set its own free chlorine level, but not above 3 mg/l (milligrams per liter, about the same as ppm) in public and semi-public pools or 5 mg/l in hot tubs. Cyanuric acid, the stabilizer that shields chlorine from sunlight, should stay between 50 and 100 mg/l and not exceed 100 mg/l. WHO notes that no comprehensive survey exists, that one US study found 25% of 486 pools above 100 mg/l, and that cyanuric acid builds up in the water and cannot be removed by treatment, only by adding fresh water.

    Lessona chemical that only dilution removes has to be planned for when the pool is filled, not after it builds up.

    iris.who.int

    Credit

    World Health Organization

  5. 2014

    A model code for pools

    No US federal agency regulates how public pools are designed, built or run; every code is written and enforced by a state or a town. In 2005 public health officials and the pool trade asked CDC for one evidence-based model, and the first edition of the Model Aquatic Health Code (MAHC) came out on 29 August 2014. Jurisdictions can adopt it in whole or in part to cut outbreaks, drownings and chemical injuries.

    pmc.ncbi.nlm.nih.gov

    Credit

    US Centers for Disease Control and Prevention (CDC), with public health, industry and academic representatives

  6. 2016

    Germs that outlast chlorine

    CDC counted 208 outbreaks of illness from pools, hot tubs and water playgrounds reported in 2015–2019, with at least 3,646 people ill and 13 deaths, all from Legionnaires' disease. The parasite Cryptosporidium caused 76 of the 155 outbreaks with a confirmed cause and 84% of their cases, and half of those 76 came in 2016. Its oocysts, the infectious stage, survive more than 7 days at 1 ppm free chlorine, the minimum most US jurisdictions require, so the 2018 MAHC recommends ultraviolet light or ozone as a second barrier, and "hyperchlorination" after a diarrhea incident: 20 ppm for 12.75 hours, or 28 hours when the water holds up to 15 ppm cyanuric acid.

    Lessona pool can meet its chlorine rule and still spread Cryptosporidium, and the stabilizer that saves chlorine outdoors slows the cleanup.

    pmc.ncbi.nlm.nih.gov

    Credit

    Michele Hlavsa and colleagues, CDC

  7. 2024

    A tablet warehouse burns

    Chlorinated isocyanurates, such as trichloroisocyanuric acid (TCCA), are the stabilized chlorine in pool tablets; a little water, as opposed to a pool's worth, makes them react, heat up and give off toxic gas. On 29 September 2024 a corroded sprinkler part leaked onto these chemicals in Bio-Lab's warehouse in Conyers, Georgia, which held nearly 14 million lb of them, more than twice what had been declared to local officials. The reaction spread, the building burned, about 17,000 people were evacuated and the site never reopened. Atmospheric chemists measured bromine 21 miles downwind in Midtown Atlanta at four times the US Environmental Protection Agency's one-hour exposure guideline. It was the company's second such loss: in August 2020 Hurricane Laura tore roofs off its Lake Charles, Louisiana, plant and rain set off the same reaction.

    LessonCSB found the sprinklers had been left to run to failure in air the chemicals themselves made corrosive, so the fire protection became the water source.

    csb.govcsb.govpmc.ncbi.nlm.nih.gov

    Credit

    US Chemical Safety Board (CSB) investigations; Charles Harper, L. Greg Huey and colleagues (plume measurements)

Watch for

  1. Robots that test the water

    Robot pool cleaners now carry cameras that recognize debris, and two makers say theirs also check water quality. Aiper says its EcoSurfer Senti, a solar-powered surface skimmer, is the "World's 1st AI Powered skimmer with water quality management", in an article it sponsored; Mammotion's SPINO S1 Pro, a CES 2026 Innovation Awards honoree, offers "optional water quality sensing" during cleaning.

    Achieved whenan outside tester compares the robots' readings of free chlorine and pH with a DPD photometer, a meter that reads the color chlorine gives a standard reagent called DPD, and a pH meter on the same water over a season, and publishes the error.

    androidauthority.comces.tech

    Claimed by

    Aiper, January 2026; Mammotion, January 2026

Open

  1. 01

    Test strip apps checked

    An independent test of the phone apps and pocket readers that read pool test strips, checked against a titration kit and a photometer on the same prepared water, under several kinds of light and on several phones.

    The brief
    Credit · unclaimed
  2. 02

    Pool inspections in one table

    An open, yearly updated table of public pool inspection results from at least 20 health departments that post them online, coded to the same critical items CDC used (disinfectant level, pH, safety equipment, pool chemical safety and others), with closure rates by year.

    The brief
    Credit · unclaimed

Open 01 · the brief

Test strip apps checked

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An independent test of the phone apps and pocket readers that read pool test strips, checked against a titration kit and a photometer on the same prepared water, under several kinds of light and on several phones.

Why it is still open

The last public head-to-head test of pool test kits found is by the National Pool Industry Research Center in San Luis Obispo, California, reported by Pool & Spa News in 2008. Against the lab value, its 14 kits read free chlorine 18.3% low on average, and test strips read it 15.5% to 45.0% low. It did not cover phone apps. App makers' accuracy claims are their own: Spark Diagnostics says its app gives "accurate results in 30 seconds". A search for a published comparison of strip-reading apps with a photometer found none. Hobby code that reads strips from phone photos is on GitHub, such as a 2023 student app for 5-way strips and a November 2026 reader for HTH strips that runs in Home Assistant; neither reports accuracy against a titration.

poolspanews.comgithub.comgithub.comapps.apple.com

Built with what exists

Tap water and unscented household bleach diluted to 0 to 10 ppm free chlorine, never mixed with acid; pH buffer solutions; a FAS-DPD titration kit, which measures chlorine by counting drops of reagent, such as Taylor Technologies' Complete kit, as the reference; a pool photometer; three or more strip brands with their apps on three phones; a light box; a vision-language model such as Claude Fable 5.2 (see the Note "Three working devices") as one more reader of the strip photos; Python for the error tables.

  1. First step

    Make 10 samples from 0.5 to 8 ppm, check each by titration, and read them with two apps in daylight and kitchen light.

  2. Done looks like

    20 samples, each read by at least 5 apps or readers on 3 phones under 3 kinds of light, every reading compared with the titration, with the mean error and the share within 1 ppm published per app; the test repeated with strips from a bottle left open for 6 months.

Open 02 · the brief

Pool inspections in one table

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An open, yearly updated table of public pool inspection results from at least 20 health departments that post them online, coded to the same critical items CDC used (disinfectant level, pH, safety equipment, pool chemical safety and others), with closure rates by year.

Why it is still open

CDC set up its Network for Aquatic Facility Inspection Surveillance in 2013. Its 2016 report covered 84,187 routine inspections in five states in 2013 and found that 12.3% ended in immediate closure and 11.9% found the disinfectant level out of range; CDC called those data "the first and most recent that are available". A search of Europe PMC found no later multi-state count. Single-place work exists: a class project analyzed New York City's open pool inspection data, and a 2026 GitHub project collects the weekly inspection status of pools in six Florida counties from the state health department.

ebi.ac.ukgithub.comgithub.com

Built with what exists

County and state health department inspection portals; a web agent such as Meta's Muse Ember (see the Note "The jobs agents repeat") to collect the reports; an AI model that answers fixed questions about each report, such as Gemini Decision 1 (see the Note "A thousand questions, one pass"), checked against reports coded by hand; the MAHC's critical items as the codebook; a GitHub repository.

  1. First step

    List the US health departments that post pool inspection results online, and hand-code 50 reports from one of them.

  2. Done looks like

    20 jurisdictions in at least 3 states, 2015 through 2025, at least 100,000 inspections; at least 95% agreement with a person on 500 hand-checked reports; closure and disinfectant-violation rates by year published and compared with the 2013 figures.