BRENNEN

Industries / Industrial equipment and services / Industrial services / Painting and abrasive blasting

Containment and waste

Containment and waste is the work of keeping blast dust, old paint and spent abrasive out of the air, water and soil around a job, then testing what was collected and disposing of it.

7

Milestones achieved, from 1996 to 2023.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1996

    Spent grit set in concrete

    Spent abrasive from bridge repainting can hold enough lead and other metals to count as hazardous waste under the US leach test. M. T. Webster and R. C. Loehr of the University of Texas at Austin mixed it into nonstructural concrete. Portland cement held the metals in, and mixes that used unseparated spent sand or slag in place of all the clean sand met both the leach limit and a strength of 6.9 MPa (1,000 psi). Some mixes never set. The authors report that the Texas Department of Transportation had begun recycling spent abrasive with Portland cement.

    LessonA mix can take only so much spent media before it stops setting.

    osti.gov

    Credit

    M. T. Webster and R. C. Loehr (Journal of Environmental Engineering, September 1996); Texas Department of Transportation

  2. 1997

    Owner and painter share waste

    In a letter of 12 March 1997 about a product brushed over old paint before removal, whose maker said its debris passed the leach test, the US Environmental Protection Agency (EPA) set out how the rules apply to paint removal debris. The waste is judged once the paint is off the structure, the leach test for lead decides whether it is hazardous, and the debris must still pass when it is disposed of, so a batch that passes once and fails a later test becomes hazardous waste. The paint contractor and the owner of the bridge or building are both its generators. Additives blended into the abrasive took the same route: the TDJ Group says it first offered Blastox, a calcium silicate additive meant to hold lead in the spent grit, in 1991, and that EPA and the states do not treat adding it before blasting as waste treatment.

    LessonPassing the test once does not settle the matter, and hiring a contractor does not move the owner's duty to it.

    rcrapublic.epa.govwwdmag.com

    Credit

    US EPA Office of Solid Waste (letter signed by Elizabeth Cotsworth); TDJ Group, by its own account

  3. 2004

    Grit dumped in a river

    In 1999 and 2000, under highway bridge contracts in northeast Arkansas, Kerrville Painting Company of Texas discharged lead-contaminated material from sandblasting into the Black River at two bridges. In November 2004 a federal court sentenced its owner to three years in prison and the company to pay $324,613 in clean-up costs. A former inspector for the Arkansas highway department was sentenced to a year in prison. Two years earlier a Pennsylvania painting firm had pleaded guilty after its workers dumped 55 tons of spent "black beauty" slag, mixed with lead paint chips blasted off a railroad bridge in Clairton, on the ground at its warehouse in 1996.

    LessonContainment rules depend on the people checking them, and in Arkansas a state highway inspector was among those convicted.

    epa.govepa.gov

    Credit

    EPA Criminal Investigation Division, with Oklahoma and Arkansas agencies and the US Department of Transportation's Inspector General

  4. 2012

    A bay dredged for shipyards

    On 14 March 2012 the San Diego Regional Water Quality Control Board ordered the shipyards on the eastern shore of central San Diego Bay, and the city, the Navy, the port, a power company and a former shipyard owner, to clean up the bay floor next to them. The sediment held copper, lead, zinc and other metals, tributyltin and PCBs; the board lists spent abrasive and paint among the wastes the yards generated, and wrote that industry-wide boatyard practice from the 1930s to the 1980s often failed to prevent discharges. By July 2016 the dischargers' contractor reported that 142,745 cubic yards (about 109,000 m³) of sediment had been dredged and 42,698 tons of sand cover placed where dredging was not possible.

    LessonGrit and paint that reach the water stay in the sediment and are paid for decades later by everyone who used the shore.

    waterboards.ca.govwaterboards.ca.gov

    Credit

    San Diego Regional Water Quality Control Board, Order R9-2012-0024; Anchor QEA for the dischargers' trust

  5. 2014

    Japan strips lead paint wet

    A 2014 notice from Japan's labor ministry required paint holding lead or other harmful substances to be removed wet, a report by the national road ministry's Matsuyama office says, and chemical paint strippers became the usual wet method. The same report says the strippers' own chemicals then caused workplace accidents. A 2022 revision of the labor ministry's notice on stripper accidents counts heavy exposure to stripper as a reason to allow dry methods, and Fukuoka Prefecture's repainting guideline (first issued 2023, revised March 2025) makes dry blasting inside fully sheeted scaffolding the default for lead and chromium coatings, with respirators for everyone in the scaffold until the debris is out. Fukuoka also notes that lead primers hold too little resin for strippers alone to remove. At Sunakozawa Bridge in Niigata in 2024, one coat of stripper left paint behind, and blasting with steel grit that was collected, sorted and reused sent about 1,011 kg of paint debris to waste from 970 m² of steel, where the contractor says about 1 tonne of debris and 40 tonnes of abrasive would be usual for 1,000 m².

    LessonA rule that kept dust down moved the work to chemicals with hazards of their own.

    skr.mlit.go.jppref.fukuoka.lg.jphrr.mlit.go.jp

    Credit

    Ministry of Health, Labour and Welfare; Fukuoka Prefecture; Ministry of Land, Infrastructure, Transport and Tourism (MLIT) Shikoku and Niigata offices; Okozu Construction (the Niigata contractor)

  6. 2018

    PCBs found in bridge paint

    Japanese paint makers added PCBs as a softener to some chlorinated rubber paints, which were painted on road bridges. After a survey by MLIT found PCB paint on bridges, rock-fall shelters and drainage pump stations, Japan's environment ministry asked every ministry on 28 November 2018 to survey the steel it owns. The ministry limits the suspect paints to those four Japanese makers produced from 1966 to January 1972 and screens structures first by their painting records. By March 2022, 200 agencies and firms had listed 35,309 structures built or repainted in 1966 to 1974, 86% of them bridges. Of the 19,535 whose PCB level was known, 127 held more than 5,000 mg of PCB per kg, with a maximum of 90,000 mg/kg.

    LessonAn ingredient chosen in the 1960s decides how paint must be removed and disposed of 50 years later, and old specifications are the first place to look.

    env.go.jpenv.go.jp

    Credit

    Japan's Ministry of the Environment, PCB Waste Management Office; MLIT

  7. 2023

    Lead paint falls statewide

    In mid-February 2023, after an unusually rapid change in temperature, inspectors for Connecticut's Department of Transportation found paint chips under an elevated section of Interstate 84 in Hartford. A check of all the department's painted steel bridges over the next days found fallen chips at 281 bridge sites, and preliminary tests confirmed lead. The commissioner declared a statewide emergency on 17 February 2023. Licensed spill contractors collected the chips, sites near parks and drinking water watersheds went first, and the state health department warned that some bridges might keep shedding paint until they were scraped and repainted. In Baltimore in 2026, by April the Maryland Department of the Environment (MDE) counted six city and state bridges shedding lead paint, after the group Blue Water Baltimore had reported three; the state highway agency said full abatement of its bridges would wait until they are repainted in 2027.

    LessonLead paint left in place without upkeep reaches soil and water on no one's schedule, and one turn in the weather can bring it down from many bridges at once.

    portal.ct.govwmar2news.com

    Credit

    Connecticut Department of Transportation and Department of Public Health; Blue Water Baltimore and MDE

Watch for

  1. Laser removal of PCB paint

    A laser vaporizes paint, which a vacuum on the laser head pulls through a HEPA filter, a filter rated to catch fine dust. On steel at a snow shelter on National Route 113 in Niigata, where the paint held 1,200 mg of PCBs per kg, the contractor used a 200 W laser from an aerial work platform instead of blasting inside a sealed enclosure. It reports that the job needed only short lane closures, that the waste was the vacuum debris, filters and protective clothing, and that it cost about 6.7 million yen, or 46.5%, less than the 14.6 million yen estimated for blasting.

    Achieved whenthe road office or an outside lab publishes measured PCB in the air near the work and the waste mass per square meter for several laser jobs, set beside blasting jobs.

    hrr.mlit.go.jp

    Claimed by

    Toa Road Corporation, Hokuriku branch, at MLIT Niigata National Highway Office's technical presentations for fiscal 2025 (work from March 2025 to March 2026)

Open

  1. 01

    Pool the leach test results

    A public table of leach test (TCLP) results for spent abrasive and paint debris from bridge and tank repainting jobs, each with the abrasive, any additive, the containment used and the lead found, and a count of how often each combination failed the 5.0 mg per liter limit.

    The brief
    Credit · unclaimed
  2. 02

    Rank bridges shedding old paint

    A public, ranked list of steel bridges whose paint is failing over water or homes, built from the federal bridge inventory, with a map and the code behind it.

    The brief
    Credit · unclaimed

Open 01 · the brief

Pool the leach test results

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public table of leach test (TCLP) results for spent abrasive and paint debris from bridge and tank repainting jobs, each with the abrasive, any additive, the containment used and the lead found, and a count of how often each combination failed the 5.0 mg per liter limit.

Why it is still open

EPA's 1997 letter puts the test on each job and says a maker's test data "could be of assistance" to users; the studies opened for this file report single programs, such as Texas's in 1996. In November 2026 a Crossref search found the ASTM guide for choosing debris samples (E1908) but no pooled set of results, and a GitHub search for "TCLP lead" returned no repositories.

rcrapublic.epa.govosti.gov

Built with what exists

Public-records requests to state transportation departments and large tank owners; EPA's e-Manifest data, which the agency publishes through its Hazardous Waste Information Platform, to find shipments of the waste; a language model such as Claude to read scanned lab reports into a fixed form (see the Notes "Seven more flagged" and "A thousand questions, one pass"); Python and pandas; a second person to check.

epa.gov

  1. First step

    Ask one state transportation department for the waste profiles and leach reports from its last 20 repainting contracts.

  2. Done looks like

    At least 300 results from at least five states or countries, from 2015 to 2025, published under an open license with the failure rate by abrasive and additive, and a check of 30 rows picked at random agreeing with the lab reports on the lead value in at least 95% of rows.

Open 02 · the brief

Rank bridges shedding old paint

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public, ranked list of steel bridges whose paint is failing over water or homes, built from the federal bridge inventory, with a map and the code behind it.

Why it is still open

Since 2015 the US Federal Highway Administration (FHWA) has collected, for every bridge on the National Highway System, how many square feet of steel coating are in each of four condition states, from good to severe (element 515). Yet Connecticut found shedding at 281 bridge sites in 2023 only after chips were seen under a highway, and in Baltimore in 2026 an advocacy group, not the inventory, first flagged the bridges dropping lead chips. A Crossref search in November 2026 found studies of bridge inventory condition data, but none ranking bridges by failed coating over water, and GitHub searches for bridge element data and bridge lead paint returned nothing.

fhwa.dot.govfhwa.dot.govportal.ct.govwmar2news.com

Built with what exists

FHWA's bridge inventory and element files for 2015 to 2025; Python, pandas and GeoPandas; OpenStreetMap for waterways and housing; the year built and, where recorded, the last repainting as a guide to which bridges may still carry lead paint, to be confirmed with each owner.

  1. First step

    Download Maryland's 2025 inventory and element files and look up the six bridges.

  2. Done looks like

    A national table of steel bridges giving the area of coating in condition states 3 and 4, what each crosses, and a rank, published with the code; and a test showing how many of the six bridges Maryland's environment department listed in April 2026 are in the inventory and where they rank among Maryland's bridges.