BRENNEN

Industries / Energy, water and waste / Oil and gas extraction / Oilfield services

Hydraulic fracturing

Hydraulic fracturing pumps water, sand and chemicals into a well at high pressure to crack the rock so oil and gas can flow; the contractors who do it also hole the casing, supply the sand and track where the cracks go.

7

Milestones achieved, from 1930 to 2024.

2

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1930

    Bullets through the casing

    Before fluid can reach the rock, the steel casing and cement must be holed, a step called perforating. In 1930 two oilfield tool salesmen, Bill Lane and Walt Wells, came up with a gun that fired steel bullets through casing, each set off electrically, and by late 1935 their company, Lane-Wells, had a small fleet of perforating trucks, according to the American Oil & Gas Historical Society. Henry Mohaupt's patent application of 24 September 1951 for a "Shaped Charge Assembly and Gun" brought the shaped charge, which focuses an explosion into a narrow jet, from the anti-tank bazooka into perforating.

    aoghs.org

    Credit

    Bill Lane, Walt Wells; Henry Mohaupt

  2. 1967

    A nuclear blast for gas

    On 10 December 1967 the US Atomic Energy Commission set off a 29-kiloton nuclear device 4,227 feet down in northwestern New Mexico to crack a tight gas formation, the Pictured Cliffs. The US Department of Energy calls Project Gasbuggy the first gas-reservoir stimulation experiment of the Plowshare program for peaceful nuclear uses. Tests from July 1968 to October 1969 produced 213 million cubic feet of gas, more than nearby conventional wells, but the gas had measurable radioactivity and a lower heat value, and the rock held fewer fractures than expected. In 1976 further testing was ruled out.

    Lessona way of breaking rock fails if it spoils what comes out of the well.

    energy.gov

    Credit

    US Atomic Energy Commission, US Department of the Interior and El Paso Natural Gas Company

  3. 2011

    Fracturing chemicals made public

    FracFocus, a website where companies list the chemicals they pumped into each fractured well, went live on 11 April 2011 with 37 companies and 444 voluntary disclosures. The Ground Water Protection Council and the Interstate Oil and Gas Compact Commission built it, and by 2022, 27 states required or allowed companies to report through it, the site says. The independent Open-FF project, sponsored by the FracTracker Alliance, counted 246,132 disclosures by November 2026 and found that more than 80% claim at least one chemical as a trade secret.

    Lessondisclosure that allows trade-secret claims leaves gaps that only outside counting shows.

    fracfocus.orgstorage.googleapis.com

    Credit

    Ground Water Protection Council; Interstate Oil and Gas Compact Commission; Open-FF

  4. 2016

    Fracturing shakes Alberta faults

    Xuewei Bao and David Eaton built a detailed earthquake catalog for a shale play in western Canada and set it against four months of injection data. The earthquakes clustered tightly in space and time near fracturing sites, and the largest, magnitude 3.9, struck weeks after injection on a fault running from the target layer down into the basement rock. Alberta's regulator now requires companies fracturing the central Duvernay shale to monitor for earthquakes, report any of local magnitude 2.0 or more within 5 km, stop after any of 4.0 or more, and share their seismic data publicly within a year.

    Lessonthe fracturing job itself can wake a hidden fault, so watching for quakes has to be part of the job.

    ebi.ac.ukaer.ca

    Credit

    Xuewei Bao and David Eaton; Alberta Energy Regulator

  5. 2018

    Water per well climbs

    Andrew Kondash and co-authors at Duke University found that from 2011 to 2016 the water used to fracture each well in major US shale regions rose by up to 770%, and reported that water used per unit of energy produced rose in every basin. In 2020 Daniel Raimi of Resources for the Future replied that fuller production data showed water per unit of energy fell 74% in the Marcellus and 19% in the Eagle Ford while rising in regions such as the Permian, for an overall rise of 19%.

    Lessonwater use looks different per well than per unit of energy produced, so any figure must say which it is.

    pmc.ncbi.nlm.nih.govpmc.ncbi.nlm.nih.gov

    Credit

    Andrew Kondash and co-authors; Daniel Raimi

  6. 2022

    Cores show many cracks

    At the first Hydraulic Fracturing Test Site in Texas's Midland Basin, a slanted well cut rock core within 18 to 30 m of two fractured horizontal wells. In about 183 m of core, University of Texas researchers counted 375 hydraulic fractures, many split, stepped or branched at layer boundaries and natural fractures, so each stage makes more crack strands than it starts. At the second test site, in the Delaware Basin, Shell-led authors compared fiber-optic strain sensing (a glass fiber in a nearby well that records the rock stretching as cracks arrive), microseismic (recordings of tiny earthquakes) and other tools. They found the cracks mostly vertical and parallel, in swarms around each perforation cluster, and noted that crack shapes had long been inferred from microseismic "event clouds" with little cross-checking.

    Lessonone way of imaging fractures is not enough; the picture has to be checked against rock that was actually cut.

    osti.govosti.gov

    Credit

    Bethany Rysak, Julia Gale, Stephen Laubach, David Ferrill; Gustavo Ugueto and co-authors

  7. 2024

    Three wells fractured together

    Simultaneous fracturing, or simul-frac, pumps two or more wells on one pad at the same time instead of in turns. The US Energy Information Administration matched FracFocus records of wells within 50 feet of each other with overlapping job dates and found that the average number of horizontal wells completed at once rose from 1.5 in 2014 to just over 3 in 2024; it called electric fracturing fleets crucial to the rise, according to JPT. The American Petroleum Institute says about 3,600 Permian wells were completed this way in 2025, more than half of the basin's total.

    jpt.spe.orgapi.org

    Credit

    fracturing contractors and operators; measured by the US Energy Information Administration

Watch for

  1. Coke proppant lifts recovery

    Proppant is the grit pumped into fractures to hold them open, usually sand. ExxonMobil says a lightweight proppant it makes from petroleum coke, a refinery byproduct, "improves well recoveries by up to 20%" in the Permian Basin. JPT reports ExxonMobil's figures as 7 to 20% more crude than offset wells, and says unnamed outside analyses support them.

    Achieved whena party outside ExxonMobil publishes a comparison from well data, with its method, that finds a gain in the claimed range.

    sec.govjpt.spe.org

    Claimed by

    ExxonMobil, October 2025

  2. Mid-stage fixes from downhole data

    ProFrac and Seismos say they fractured 183 stages on a four-well pad in the Eagle Ford and Austin Chalk from 13 February to 4 March 2026 under closed-loop control: measurements from inside the well changed pumping settings within a stage, on average less than five minutes after the data arrived. They report that stages with such changes had 7% better perforation efficiency mid-stage and 7.5% better at the end than stages without; perforation efficiency is the share of casing holes that take fluid.

    Achieved whenthe operator or another outside party publishes production results from these or later wells showing the gain.

    ir.pfholdingscorp.com

    Claimed by

    ProFrac Holding Corp. and Seismos, March 2026

Open

  1. 01

    Check the coke proppant claim

    An outside comparison of oil output from wells fractured with ExxonMobil's petroleum-coke proppant against similar nearby wells fractured with sand, using only public records, with the method and well list published.

    The brief
    Credit · unclaimed
  2. 02

    Test simul-frac well output

    A public comparison of production from wells fractured simultaneously with wells fractured in turns ("zipper" fracturing, which alternates stages between neighboring wells), using FracFocus job dates to tell them apart and state production records to score them.

    The brief
    Credit · unclaimed

Open 01 · the brief

Check the coke proppant claim

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An outside comparison of oil output from wells fractured with ExxonMobil's petroleum-coke proppant against similar nearby wells fractured with sand, using only public records, with the method and well list published.

Why it is still open

JPT says outside analyses support ExxonMobil's 7 to 20% figure but does not name them, and none with public data and method was found. The raw material is public: Open-FF's November 2026 report lists 50 FracFocus disclosures of petroleum coke (CAS 64741-79-3) from October 2021 to August 2026; of the 49 with full data, 32 were filed by Pioneer Natural Resources, which ExxonMobil bought in May 2024, and 17 by XTO Energy, 39 of them in Texas and 9 in New Mexico.

jpt.spe.orgstorage.googleapis.comsec.gov

Built with what exists

Open-FF's cleaned FracFocus data; production records from the Texas Railroad Commission and New Mexico's Oil Conservation Division; Python for matching treated wells with sand wells of the same operator, rock layer, year and lateral length.

  1. First step

    Download Open-FF's list of the coke disclosures, pull 12 months of production for the New Mexico wells, and find sand-only neighbors on the same pads.

  2. Done looks like

    For at least 40 coke-proppant wells, 12-month oil output per foot of lateral compared with at least 200 matched sand wells, with the difference and its 90% confidence interval published alongside the code and well list.

Open 02 · the brief

Test simul-frac well output

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public comparison of production from wells fractured simultaneously with wells fractured in turns ("zipper" fracturing, which alternates stages between neighboring wells), using FracFocus job dates to tell them apart and state production records to score them.

Why it is still open

The Energy Information Administration's count measured how common simultaneous jobs are, not how the wells produce. A 2023 ResFrac simulation of a generic shale well pair found five-year oil 13% lower for simul-frac with the same stage design, because the pumps are split and each well gets fluid at a lower rate; it made no comparison with field production.

jpt.spe.orgresfrac.com

Built with what exists

Open-FF's FracFocus data; the EIA's rule for spotting simultaneous jobs (wells within 50 feet with overlapping job dates); state production records; Python. No new AI is needed; the enabling step is FracFocus data that Open-FF has already cleaned.

  1. First step

    Apply the EIA rule to one county in Open-FF, and check 20 of the pads it flags against operators' state completion reports.

  2. Done looks like

    At least 1,000 simul-frac wells and 1,000 zipper-frac wells matched by basin, rock layer, year, lateral length and proppant per foot, with the difference in 12-month and 24-month output per foot and its confidence interval published, and a second analyst rerunning the code to the same figures.