Industries / Technology / Telecommunications
Fiber and cable
Fiber and cable is building and running the wired networks, on land and under the sea, that carry calls and data: copper and coaxial cable at first, glass optical fiber today, and the cable TV lines that now also carry internet service.
7
Milestones achieved, from 1858 to 2024.
2
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
In depth
The same ground is charted in more depth, as an industry of its own.
The road
AchievedWatch forOpen
Achieved
1858
The first Atlantic cable fails
The ships Niagara and Agamemnon finished a telegraph cable across the Atlantic from Valentia, Ireland, on 5 August 1858, and it worked for only a few weeks. The Linda Hall Library gives 2 September as the day it failed; IEEE's history says it was dead by 18 September. The National MagLab says Queen Victoria's first public message, under 100 words, took more than 16 hours to send and receive. The chief electrician, Wildman Whitehouse, drove the cable with an induction coil that may have put about 2,000 volts on it, and an 1861 board of inquiry blamed him, though critics say the cable was also badly made and handled. A cable laid in 1866 worked, and five more joined Ireland and Newfoundland by 1894.
Lessonpushing a weak signal harder can destroy the line; the fix was a more sensitive receiver.
Credit
Cyrus Field, who organized the effort; William Thomson, later Lord Kelvin, whose mirror galvanometer, a very sensitive current detector, could read the faint signals
1956
Voices under the ocean
TAT-1, the first transatlantic undersea telephone system, went into service on 25 September 1956 between Oban, Scotland, and Clarenville, Newfoundland. It opened with 29 circuits between London and New York and 6 between London and Montreal. Each of its two cables, one for each direction, had 51 repeaters, amplifiers sealed into the cable about 37 miles apart. It ran until 1978.
Credit
AT&T Bell Laboratories; the British Post Office; the Canadian Overseas Telecommunication Corporation.,_1956)
1970
Glass clear enough for light
In 1966 Charles Kao, at Standard Telecommunication Laboratories in Harlow, UK, calculated that fiber made of very pure glass could carry light signals over 100 km, against about 20 meters for the fibers of the 1960s; he shared the 2009 Nobel Prize in Physics for it. In 1970 Robert Maurer, Peter Schultz and Donald Keck at Corning made a fiber that lost 17 dB per kilometer (decibels measure signal loss; a 20 dB loss leaves 1% of the light), better than the goal of about 20 dB/km set for the British Post Office. IEEE calls it the world's first low-loss optical fiber for telecommunications.
Credit
Charles K. Kao; Corning (Maurer, Schultz and Keck)
1988
Fiber crosses an ocean
TAT-8 entered service on 14 December 1988 across 5,846 km of seabed between North America and Europe. IEEE calls it the first fiber-optic cable to cross an ocean. Its repeaters ran at 280 Mbps (megabits per second), enough for about 40,000 telephone calls, which IEEE puts at ten times the last copper cable.
Credit
AT&T, British Telecom and France Telecom, which led the owning group; AT&T Bell Laboratories, which developed the fiber, lasers and repeaters and put the system together.,_1988)
1996
Light amplified as light
Early fiber cables had electronic repeaters every few tens of kilometers that turned the light into electricity, cleaned it up and turned it back. The erbium-doped fiber amplifier is a short length of fiber laced with the element erbium that boosts the light directly. A University of Southampton group filed patents on it in 1985 and in 1987 published what the university calls the first practical optical amplifier. IEEE Spectrum reports it went into service in the transatlantic TAT-12 system in 1996. Because it amplifies many wavelengths at once, one fiber can carry many signals side by side, each on its own color of light, a method called wavelength-division multiplexing; IEEE Spectrum says this raised capacity more than a thousandfold.
Credit
R. J. Mears, L. Reekie, I. M. Jauncey and D. N. Payne (University of Southampton); Bell Labs, for practical pump lasers that power the amplifiers, per IEEE Spectrum
1996
Cable TV carries the internet
Cable TV networks were built to send television one way, into homes. CableLabs, the cable industry's research group, lists 1996 as the year of the first DOCSIS specification (Data Over Cable Service Interface Specification), the standard that lets a cable modem send and receive internet data over those lines. The ITU, the UN's telecom agency, publishes DOCSIS's radio rules as Annex B of its recommendation J.112. CableLabs' DOCSIS 4.0, first specified in 2019, allows up to 10 Gbps down and 6 Gbps up; CableLabs notes these are specification figures and real networks vary.
Credit
CableLabs; ITU-T
2024
An anchor cuts three cables
In late February 2024 three of the more than a dozen cables in the Red Sea, Seacom, AAE-1 and EIG, were cut. Ryan Wopschall of the International Cable Protection Committee (ICPC), an industry body, said it was generally accepted that the cargo ship Rubymar, hit by Houthi missiles in mid-February, dropped an anchor that dragged across them. HGC Global Communications estimated the three carried about 25% of the region's traffic. Repair needed months of negotiation with Yemen's two rival governments, and AAE-1 was back in service in July 2024, Bloomberg reported. On 29 November 2024 the ITU and the ICPC formed the International Advisory Body for Submarine Cable Resilience; the ICPC estimates 150 to 200 cable faults a year worldwide, and the ITU lists fishing and anchoring first among the causes.
Lessonin a conflict zone the slow part of a repair can be the permit, not the ship.
Credit
the ITU and the ICPC (advisory body)
Watch for
Hollow-core fiber loss records
Hollow-core fiber guides light through air inside a fine glass structure instead of through solid glass. A team from Microsoft Azure Fiber and the University of Southampton reports a loss of 0.091 dB/km at 1,550 nm, below the 0.14 dB/km that the best solid silica fibers have reached in four decades, and says light in it travels 45% faster. The paper says Microsoft already uses fiber of this type in its own private network. At the ECOC optical conference the same month, the Chinese fiber makers YOFC and Linfiber Technology reported 0.05 dB/km and 0.052 dB/km (over 40 km). Each figure was measured by the team that made the fiber.
Achieved whenan outside lab or network operator measures loss below 0.14 dB/km on installed cable and publishes the result.
Claimed by
M. Petrovich, F. Poletti and co-authors, Nature Photonics, September 2025; YOFC and Linfiber Technology, September 2025
Cables that hear anchors
Distributed acoustic sensing (DAS) sends light pulses down a fiber and reads tiny changes in the light scattered back, turning the cable into a long microphone. In June 2026 the Finnish operator Elisa, with Finland's Border Guard and Navy, tested DAS on an undersea cable against staged threats, including a ship dragging its anchor, and called the trials successful without publishing detection rates. IEEE Spectrum reports that an upgraded DAS system from Alcatel Submarine Networks can warn up to 15 minutes and 2 km before an anchor or trawl gear reaches a cable.
Achieved whena cable owner publishes how many real approaches the system caught and missed over a year, and someone outside the seller checks the count.
Claimed by
Elisa, June 2026; Alcatel Submarine Networks, as reported by IEEE Spectrum, September 2026
Open
01
An open cable repair log
A public table of undersea cable faults, one row per fault: the date, the cable, the cause where one was reported, the date service came back, and links to the notices behind each field.
The briefCredit · unclaimed02
A shared cable modem logbook
An open dataset of the signal readings that home cable modems show on their status pages (power level, signal-to-noise ratio and error counts for each channel), logged every five minutes by volunteers on their own modems, with every outage labeled, and a simple model that tries to warn of an outage a day ahead.
The briefCredit · unclaimed
Open 01 · the brief
An open cable repair log
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public table of undersea cable faults, one row per fault: the date, the cable, the cause where one was reported, the date service came back, and links to the notices behind each field.
Why it is still open
Northwestern University's AquaLab Sentinel project lists 134 cable incidents from 2017 to 2026 by type, severity and status, but gives no cause or repair time. TeleGeography's dashboard of publicly known faults is for paying subscribers. The ICPC publishes an estimate of 150 to 200 faults a year, and its comparison of how long repairs take to start, updated in August 2026, gives only aggregate figures, does not identify individual cables, repairs or operators, and is sent only on request.
aqualab.cs.northwestern.eduresources.telegeography.comitu.intiscpc.org
Built with what exists
Sentinel's event list; operators' and regulators' notices; ship-tracking data from Global Fishing Watch, which the open shadow-ship-check tool on GitHub already uses to study ships near cable incidents, to see when a repair ship reaches a site; a language model that drafts each row and cites the sentence it came from (see the Note "Findings that cite notes"); two people who check every row.
First step
Take Sentinel's 2025 list and find an operator or regulator notice for ten of its incidents.
Done looks like
All 62 Sentinel incidents from 2024 and 2025 with a cause or "not reported", a fault date, a restoration date or "not reported", and a source link for each field, with the second checker agreeing on at least 90% of cause codes, published under an open license.
Open 02 · the brief
A shared cable modem logbook
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
An open dataset of the signal readings that home cable modems show on their status pages (power level, signal-to-noise ratio and error counts for each channel), logged every five minutes by volunteers on their own modems, with every outage labeled, and a simple model that tries to warn of an outage a day ahead.
Why it is still open
Cable operators already collect these readings from modems to find faults before customers notice, under CableLabs' Proactive Network Maintenance work, but the data stays with each operator. Hobby scripts that read a modem's status page exist, such as arris_cable_modem_stats, but each logs one home into a private database. Searches of GitHub and Hugging Face in November 2026 found no shared, labeled dataset.
Built with what exists
Open modem scrapers such as arris_cable_modem_stats; a Raspberry Pi in each home; InfluxDB and Grafana; a gradient-boosting model in Python; a consent form and a script that removes addresses and serial numbers before upload.
First step
Set up one logger on one modem, publish the data schema, and recruit ten volunteers from a cable users' forum.
Done looks like
At least 50 homes on at least three cable operators logging for six months, every outage longer than ten minutes labeled, and the model's precision and recall for day-ahead warnings published against a baseline that never warns.