BRENNEN

Industries / Construction and property / Commercial and residential construction / Roofing

Roofer safety

Roofer safety is the work of keeping people on roofs from falling off edges, through skylights and fragile sheets, or from ladders, and the rules that say when they must be protected and how.

6

Milestones achieved, from 1994 to 2025.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1994

    Rules written for roofs

    OSHA's fall protection rules, published on 9 August 1994, gave roofing work its own paragraphs. On a low-slope roof, one that rises no more than 4 in 12 (4 inches up for every 12 inches across), roofers 6 ft (1.8 m) or more above a lower level must be protected by guardrails, safety nets or personal fall arrest (a harness and line tied to an anchor), or by a warning line combined with one of those or with a safety monitor. A warning line is a barrier set back from the edge that marks where roofing may go on without other protection; a safety monitor is a competent person who watches for fall hazards and warns workers. On roofs 50 ft (15.25 m) wide or less, a safety monitor alone is allowed. On steeper roofs only guardrails with toeboards, nets or fall arrest count, and holes, including skylights, must be covered or guarded.

    osha.govosha.gov

    Credit

    US Occupational Safety and Health Administration (OSHA)

  2. 2000

    A drop test for fragility

    In Britain a roof is classed as fragile or non-fragile by dropping a 45 kg sandbag 1.2 m onto a sample of the whole roof as it would be installed, a load the UK Health and Safety Executive (HSE) found typical of a person tripping and falling onto a roof. Roofing trade bodies formed the Advisory Committee for Roofsafety (ACR), which published the test as ACR(M)001:2000; its fifth edition (2014), known as the Red Book, grades roofs A to C, by the account of a rooflight maker's technical manager. HSE says falls through fragile surfaces, mostly fiber-cement sheets and rooflights (plastic or glass panels set into a roof to let in daylight), cause 22% of construction deaths from falls, and tells firms to treat every roof as fragile until a competent person has confirmed otherwise.

    LessonHSE's earlier drop test checked products on their own and missed the joints between them, so the new test covers the roof as built.

    mail.specificationonline.co.ukhse.gov.uk

    Credit

    HSE; the Advisory Committee for Roofsafety

  3. 2005

    Britain sets no minimum height

    The Work at Height Regulations 2005 came into force on 6 April 2005. They define work at height as work in any place from which a person could fall far enough to be hurt, with no minimum height, and require employers to avoid it where they reasonably can. Regulation 9 requires employers to keep workers off and away from fragile surfaces where that is practicable, and otherwise to provide platforms, coverings or guard rails and post warning notices at the approach. HSE says almost one in five deaths in construction involve roof work, and that many of those killed were repairing or cleaning roofs rather than working as specialist roofers.

    legislation.gov.ukhse.gov.uk

    Credit

    the UK Health and Safety Commission, which proposed the regulations, and the UK government

  4. 2010

    Home roofs lose an exemption

    On 8 December 1995 OSHA issued an interim policy that let residential builders use other procedures instead of guardrails, nets or harnesses without first showing that these were infeasible or writing a site-specific plan. On 16 December 2010 it rescinded the policy, noting that "there continue to be high numbers of fall-related fatalities in residential construction", and began enforcing the 6 ft rule on home building on 16 June 2011. A study by CPWR (the Center for Construction Research and Training) had counted 2,163 deaths from roof falls among the 6,591 US construction deaths from falls between 1992 and 2009, with higher risk in residential work and at small firms.

    LessonAn interim relaxation stayed in place for 15 years while the deaths continued.

    osha.govehstoday.com

    Credit

    OSHA; CPWR, for the count

  5. 2023

    Inspections on sight

    OSHA's National Emphasis Program on falls, effective 1 May 2023, lets its compliance officers open an inspection whenever they see someone working at height, including while driving between other inspections. It covers every fall-related inspection in construction and, outside construction, jobs such as rooftop mechanical work, gutter cleaning and chimney cleaning, and it encourages inspectors to use small drones.

    osha.gov

    Credit

    OSHA

  6. 2025

    California moves to six feet

    From 1 July 2025 California's construction safety orders require fall protection in residential framing and roofing from 6 ft, consistent with the federal rule; a 2004 state rule had set a single 15 ft trigger height for residential-type framing work. Federal OSHA told the state's Standards Board in 2013 that its residential rules were not as effective as the federal ones, the board began rulemaking in 2016, and in April 2025 federal OSHA found the new rules at least as effective. Builders' groups and the carpenters' union petitioned for a year's delay; on 18 September 2025 the board granted the petition only to the extent of convening an advisory committee on fall protection plans for interior framing, leaving the July 2025 date in place.

    LessonBringing one state's rule for house roofs down to the national height took nine years of rulemaking after the 2013 warning.

    dir.ca.govdir.ca.gov

    Credit

    California Occupational Safety and Health Standards Board; federal OSHA

Watch for

  1. Foot sensors catch falls

    Researchers at Texas State University recorded people wearing motion sensors and pressure-sensing insoles on a laboratory roof mock-up tilted at 0°, 15° and 30° while they stood, walked, stooped, knelt and acted out falls. They report that a model using three motion sensors and two insole sensors detected falls with an F1 score of 0.88 (a measure that balances missed falls against false alarms, where 1 is perfect), better than a full set of 17 motion sensors.

    Achieved whenanother group repeats the result, or a trial on working roofers reports detection and false-alarm rates over full shifts.

    api.crossref.org

    Claimed by

    Tarek Mahmud, Rujan Kayastha, Krishna Kisi, Anne Hee Ngu and Sana Alamgeer, in the journal Electronics, July 2025

Open

  1. 01

    Roof falls, coded by case

    An open table of every roof-fall death in OSHA's published investigation summaries since 2015, each coded for roof slope, residential or commercial work, new roof or reroof, fall height, how the person fell (over an edge, through a skylight or fragile surface, from a ladder at the eave, with a collapsing roof) and whether fall protection was provided and whether it was in use, with code that rebuilds the table each year. An AI model drafts the codes from each narrative and people check them. No one goes on a roof.

    The brief
    Credit · unclaimed
  2. 02

    Fall rules, country by country

    A public table of the rules that protect roofers from falls in at least 40 countries: the height above which protection is required at a roof edge, whether steep roofs have their own rule, what the law says about skylights and fragile surfaces, and whether house building or short jobs are treated differently. Every cell links to the clause of law it comes from.

    The brief
    Credit · unclaimed

Open 01 · the brief

Roof falls, coded by case

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An open table of every roof-fall death in OSHA's published investigation summaries since 2015, each coded for roof slope, residential or commercial work, new roof or reroof, fall height, how the person fell (over an edge, through a skylight or fragile surface, from a ladder at the eave, with a collapsing roof) and whether fall protection was provided and whether it was in use, with code that rebuilds the table each year. An AI model drafts the codes from each narrative and people check them. No one goes on a roof.

Why it is still open

The coded record of whether fall protection was there stops in 2015. CPWR coded all 768 construction deaths in NIOSH's FACE investigation reports from 1982 to mid-2015 into a free database and found that about 70% of fall victims in roofing, siding and sheet metal firms had no personal fall arrest system available. Later studies of OSHA's roofing records coded other things: Onuchukwu and Esmaeili (2022) studied injury source, cause and body part in over 600 reports, Rouf and colleagues (2025) the time of day and season of 802 roof accidents from 2014 to 2023, and a 2025 University of Houston thesis used GPT-4o to pull general fields from 28,000 OSHA reports. None published a case table of protection provided and used. OSHA's search tool has no export.

ebi.ac.ukishn.comapi.openalex.orgnemo.asee.orgarxiv.orgosha.gov

Built with what exists

OSHA's accident investigation search, which holds narrative summaries of completed investigations from 1984 with keyword and fatality-only filters; CPWR's Construction FACE Database as a model for the codes; a browser agent such as Browser Use to collect summaries slowly and within the site's terms (see the Note "Deleting 80% to start over"); a low-cost AI model to draft the codes (see the Note "The jobs agents repeat"); a spreadsheet for two human coders.

  1. First step

    Search OSHA's tool for "roof" with the fatality-only filter for one event year, and hand-code the first 50 summaries to settle the codebook.

  2. Done looks like

    Every roof-fall death in OSHA's summaries with event dates from 2015 to 2024 coded and published with the code that built the table; two people independently code a random 10%, with agreement on the two protection fields of at least 0.8 by Cohen's kappa (a measure of agreement beyond chance); and a first chart setting the share with no protection provided beside the FACE database's 70%.

Open 02 · the brief

Fall rules, country by country

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public table of the rules that protect roofers from falls in at least 40 countries: the height above which protection is required at a roof edge, whether steep roofs have their own rule, what the law says about skylights and fragile surfaces, and whether house building or short jobs are treated differently. Every cell links to the clause of law it comes from.

Why it is still open

The comparisons found are small. A 2020 study by Kim Dae Young and colleagues in the Journal of the Korea Institute of Building Construction compared fall rules in South Korea, Japan, the US, the UK and Singapore, and trade websites give partial lists without citations. The rules also change: California brought house roofing down to 6 ft only in July 2025. Searches in November 2026 found no sourced table of roof-work fall rules covering most of the world.

koreascience.krdir.ca.gov

Built with what exists

Official law sites such as legislation.gov.uk and the US eCFR, and national law portals; the International Labour Organization's NATLEX database of national labor laws; an AI model that reads law text in many languages, drafts each row and quotes the clause for a person to check (see the Note "The jobs agents repeat").

  1. First step

    Fill the table for ten places whose laws are published in English, starting with the US, the UK, Ireland, Ontario, British Columbia, New South Wales and New Zealand.

  2. Done looks like

    40 countries complete, every cell linked to its clause, with a second reader checking a random 20% of cells against the law text and the error rate published.