BRENNEN

Industries / Energy, water and waste / Propane distribution

Tanks and cylinders

This is the work of choosing, filling, checking and installing the containers that hold propane at a customer's home, farm or business, from small cylinders that are swapped or refilled to large tanks set on site, together with the regulators and piping that carry the gas to the building.

6

Milestones achieved, from 1927 to 2000.

2

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1927

    Rules for cylinder installations

    The National Fire Protection Association (NFPA), a US standards body, first set standards for liquefied petroleum gas in 1927, and they covered only installations above ground that used cylinders or drums. A 1951 report by the American Society of Planning Officials says that these rules were later widened into Pamphlet 58, whose sections by then also covered containers other than standard shipping cylinders, tank trucks, storage away from the point of use, motor fuel and trailers. By 1950, by the industry's own count in a letter printed with that report, bottled and tank gas served more than 7.5 million US families, most of them for cooking.

    planning.org

    Credit

    National Fire Protection Association

  2. 1995

    Two regulators, not one

    A regulator is a valve that lowers the gas pressure from the tank, which can run from about 10 to 250 pounds per square inch, to the low pressure appliances burn, about 11 inches of water column (under half a pound per square inch). In a two-stage system a first regulator at the tank cuts the pressure to 10 pounds per square inch or less, and a second one at the building cuts it to appliance pressure. A US Department of Transportation guidance manual for small propane system operators, dated 2000, says that under the 1995 edition of NFPA 58 single-stage regulators may no longer be installed on fixed piping systems, leaving them for small portable and outdoor cooking appliances.

    webarchive.library.unt.edu

    Credit

    National Fire Protection Association (NFPA 58, 1995 edition)

  3. 1996

    Brazil retests its cylinders

    Most Brazilian homes cook with gas from a steel cylinder holding 13 kg, called the P13. In 1996 Brazil's LPG distributors signed a code of conduct that set each company a target for requalifying cylinders, that is, inspecting each one at set intervals under the standard ABNT NBR 8865 and scrapping those that fail by crushing and puncturing them, and that set up swap centers where each company's cylinders are traded back to their owner. The regulator, the National Agency of Petroleum, Natural Gas and Biofuels (ANP), publishes the counts: from 1996 to September 2026 distributors requalified or scrapped about 333.7 million P13 cylinders, scrapped 32.9 million of them, and the fleet grew from 81.9 million to 138.1 million cylinders. In November 2026 Brazil's National Energy Policy Council kept the rule that cylinders of up to 13 kg are sold full, sealed and embossed with the distributor's brand, after ANP had suspended, on 12 June 2026, a reform that would have let companies fill other brands' cylinders.

    gov.brtribunadosertao.com.br

    Credit

    Brazil's LPG distributors; records kept by ANP

  4. 1998

    A farm tank explodes

    On 9 April 1998 an all-terrain vehicle struck two aboveground propane pipes beside an 18,000-gallon tank at the Herrig Brothers turkey farm in Albert City, Iowa. Leaking propane caught fire under the tank, and less than half an hour later the tank burst in a BLEVE (boiling liquid expanding vapor explosion: a tank heated by fire weakens and ruptures), killing two volunteer firefighters about 100 feet away and injuring seven other responders. The US Chemical Safety and Hazard Investigation Board found that the pipes had no barrier against vehicles and that the excess flow valve on the liquid line, a valve meant to shut when a pipe breaks, failed to close because the pipe downstream was too narrow to let enough propane flow to trip it; tests after the accident showed the valve would have worked with properly sized pipe.

    Lessonan excess flow valve only protects a tank if the piping after it can carry enough flow to make it shut.

    csb.govcsb.gov

    Credit

    investigated by the US Chemical Safety and Hazard Investigation Board

  5. 1998

    A stop against overfilling

    An overfilling prevention device (OPD) is a backup shutoff in the filling valve of a cylinder that stops filling before the cylinder passes its permitted limit. The 1998 edition of NFPA 58 required one on cylinders holding 4 to 40 pounds of propane that were made or requalified after 30 September 1998, and on every such cylinder refilled on or after 1 April 2002; for most people that means the 20-pound grill cylinder. The US Department of Transportation explained in an advisory that its own hazardous materials rules never adopted the requirement, so it applies where states have made NFPA 58 law, and that forklift and welding-gas cylinders were exempt.

    webarchive.library.unt.edu

    Credit

    National Fire Protection Association (NFPA 58, 1998 edition)

  6. 2000

    Cylinders made without steel

    Ragasco, of Raufoss, Norway, began making LPG cylinders from composite, plastic reinforced with fibers, in 2000. By the company's own count it has sold more than 25 million, can make about 2 million a year and holds approvals in nearly 100 countries; its cylinders are lighter than steel and do not rust. Others now use the design: in July 2026 Indian Oil began bringing 10 kg composite cylinders of fiber-reinforced plastic, whose translucent body shows how much gas is left, to cities including Indore, alongside a 5 kg version.

    ragasco.comfreepressjournal.in

    Credit

    Ragasco (part of Hexagon Composites until 2024, now of Worthington Enterprises); Indian Oil Corporation

Watch for

  1. Swap, not refill, in Ghana

    Under Ghana's Cylinder Recirculation Model, a customer hands an empty cylinder in at an exchange point and takes a full one, and the empty goes to a licensed bottling plant for filling, in place of refilling customers' own cylinders at stations near homes. The National Petroleum Authority (NPA) began it on 1 September 2023, saying most accidents at filling stations happen while gas is being filled or discharged, and planned to run it beside the old refill stations for three years. In November 2025 NPA's chief executive, Godwin Kudzo Tameklo, said that through the model the authority ensures all cylinders are safely filled, inspected and distributed through licensed bottling plants, and that it would run side by side with refill stations after objections from bulk distributors.

    Achieved whenan outside party reports what share of Ghana's household LPG reaches customers through exchange points, and how accidents at filling points changed after the switch.

    npa.gov.ghgna.org.gh

    Claimed by

    National Petroleum Authority of Ghana, November 2025

  2. Recycling composite cylinder waste

    Ragasco said that from the last quarter of 2025 it would send the composite waste from making its cylinders to Gjenkraft, a Norwegian company that heats composite waste to recover the glass and carbon fibers and resins, so that nearly all of its factory waste is recovered. Gjenkraft had raised NOK 60 million for a first commercial plant in Høyanger with a capacity of up to 2,800 tonnes a year. The claim covers factory waste, not cylinders at the end of their life.

    Achieved whenthe Høyanger plant is running and an outside party, such as an auditor or regulator, reports the tonnes of Ragasco waste recycled and what the recovered fibers became.

    ragasco.com

    Claimed by

    Ragasco and Gjenkraft, October 2025

Open

  1. 01

    Brazil's cylinder record, tabulated

    One machine-readable table of everything ANP has published on Brazil's 13 kg cylinders since 1996: cylinders bought, requalified, scrapped and in service, by distributor and by year, with the share scrapped each year and a page reference for every number.

    The brief
    Credit · unclaimed
  2. 02

    Grading used cylinders by photo

    A set of photographs of used steel cylinders taken at a requalification plant, each labelled with the inspector's decision (back into service, repair or scrap) and the defect that decided it, such as a dent, a gouge, rust pitting, fire damage or a damaged foot ring, and a model scored against those decisions.

    The brief
    Credit · unclaimed

Open 01 · the brief

Brazil's cylinder record, tabulated

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

One machine-readable table of everything ANP has published on Brazil's 13 kg cylinders since 1996: cylinders bought, requalified, scrapped and in service, by distributor and by year, with the share scrapped each year and a page reference for every number.

Why it is still open

ANP's index page offers the series only as one PDF a year, for 2007 to 2026, and its tables are rotated and lose their columns when read by ordinary text tools. The files also disagree: the 2025 file gives 312.4 million cylinders requalified or scrapped through 2025, and the 2026 file gives 316.6 million for the same span. No machine-readable copy was found. Read as one series, it is a 30-year public record of a national cylinder fleet that few countries publish.

gov.brgov.br

Built with what exists

Python with PyMuPDF's table finder or pdfplumber; a vision-language model to read the rotated tables, quoting the page for each value (see the Note "Findings that cite notes"); a spreadsheet; two human checkers.

  1. First step

    Download the 20 yearly PDFs and extract the national TOTAL rows from each.

  2. Done looks like

    A published CSV that reproduces ANP's national totals for every year to the unit (for example a fleet of 138,096,711 cylinders and 32,938,873 scrapped since 1996, in the 2026 file to September), with a list of every place where two yearly files give different numbers for the same year.

Open 02 · the brief

Grading used cylinders by photo

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A set of photographs of used steel cylinders taken at a requalification plant, each labelled with the inspector's decision (back into service, repair or scrap) and the defect that decided it, such as a dent, a gouge, rust pitting, fire damage or a damaged foot ring, and a model scored against those decisions.

Why it is still open

The closest published work, Burhan Duman's January 2025 paper in Applied Sciences, trained a YOLOv5 object detection model to find surface defects on LPG cylinders as a factory quality check, not on used cylinders at requalification, and no image set tied to requalification decisions was found. The volume is large: Brazil's distributors scrapped about 597,000 P13 cylinders in 2025 by ANP's count, and US rules let most propane cylinders be requalified by an external visual inspection under the Compressed Gas Association's pamphlet C-6.3 in place of a pressure test.

library.kab.ac.uglaw.cornell.edu

Built with what exists

Phone cameras on a fixed rig with even lighting; an annotation tool such as CVAT or Label Studio; an object detection or segmentation model such as YOLO; a vision-language model to describe borderline cases; the plant's own inspection sheets.

  1. First step

    Ask one requalification plant to let a student photograph a day's empty cylinders before inspection, next to the inspector's decision sheet. Only empty cylinders are handled, and only photographs are taken.

  2. Done looks like

    At least 2,000 labelled cylinders; on a held-out set of 300, the model flags at least 95% of the cylinders the inspectors scrapped, and the share of good cylinders it wrongly flags is published.