Industries / Energy, water and waste / Pipelines and midstream / LNG
Storage tanks
Storage tanks hold LNG at about minus 160 °C and near atmospheric pressure at liquefaction plants and import terminals, using an inner tank that stays tough in the cold and insulation to keep heat out.
7
Milestones achieved, from 1944 to 2023.
1
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
The road
AchievedWatch forOpen
Achieved
1944
The wrong steel
On 20 October 1944 vapor leaked from Tank No. 4, the newest tank at the East Ohio Gas plant in Cleveland, mixed with air and exploded; a second tank exploded about 20 minutes later, and the fire killed about 130 people, the Encyclopedia of Cleveland History says. The tank's inner shell was low-carbon steel with 3.5% nickel, which its designers knew to be brittle at about minus 162 °C, and its fragments showed cold embrittlement and failure at welds, according to Theodore Lemoff's history for the National Fire Protection Association, which draws on the US Bureau of Mines report of 1946. That report could not prove what set off the failure.
Lessonthe inner tank must be made of a material that stays tough at LNG temperature.
Credit
East Ohio Gas Company (operator); US Bureau of Mines (investigation)
1954
Nickel steel holds the cold
Steels with 9% nickel have been accepted for very cold service by the American Society of Mechanical Engineers' code since 1954, according to a paper by A. S. Adamou of the Abu Dhabi gas company ADGAS. Large inner tanks are still usually welded from 9% nickel steel because it costs less than stainless steel or aluminum at that size. The tank builder CB&I says it tested 9% nickel steel for cold service and built the world's first double-wall LNG tank, an inner tank inside an outer tank with insulation between, in 1958; that "first" is its own claim.
Credit
American Society of Mechanical Engineers (code); CB&I (Chicago Bridge & Iron)
1970
Tanks set in the ground
IHI Plant Services built Japan's first in-ground LNG tank at Tokyo Gas's Negishi terminal in 1970. In these tanks the liquid sits below ground level, held by a thin inner lining called a membrane that is designed to take up the shrinking and swelling caused by temperature changes. The design was developed in Japan with Tokyo Gas, and IHI Plant Services has built 37 such tanks. In 2026 Guinness World Records certified Tokyo Gas's No. 4 tank at Ohgishima, 250,000 m³, built in 2013 by IHI Plant Services and Shimizu, as the largest in-ground LNG tank.
Credit
Tokyo Gas; IHI Plant Services; Shimizu
1971
Layers that turn over
In August 1971 a terminal at La Spezia, Italy, filled a 50,000 m³ tank through the bottom with a cargo that had warmed and grown denser while the ship Esso Brega waited in harbor for over a month. The heavier cargo stayed under the lighter LNG already in the tank. About 31 hours after loading began the layers suddenly mixed, an event called rollover, and the tank released about 86 tonnes of vapor through its relief valves and vent; no one was hurt. In 1993 a rollover at the Partington peak-shaving plant in England vented about 150 tonnes, 68 days after filling ended. Its operator then limited the density difference between new LNG and the LNG already in a tank to 5 kg/m³ and kept nitrogen below 0.8%.
LessonLNG of different densities can sit in layers for weeks and then mix all at once, so filling and density checks matter.
Credit
SIGTTO, the gas carrier and terminal operators' society (account, 2012); J. A. Sarsten (1972 report on La Spezia)
1986
Full containment tanks
A full containment tank has an outer tank, usually of concrete, that can hold both the liquid and its vapor if the inner tank leaks. EEMUA, a users' association for engineering equipment, says the first edition of its publication 147, in the mid-1980s, was the first in the world to define the types of refrigerated gas tanks, including full containment, and that its recommendations were later adopted into international standards. CB&I says it designed and built the first full containment LNG tank in 1986.
Credit
EEMUA (definition); CB&I (first tank, by its own account)
2015
Tanks outlive their design
ADGAS had three double-wall LNG tanks in service since 1985 that were reaching their design life. Adamou's paper notes that ordinary storage tanks have a standard for inspection and repair, API 653, but that none existed to recertify cryogenic tanks; ADGAS used a risk assessment built on each tank's inspection and operating history and a comparison with other tanks. In 2016 EEMUA published a third edition of publication 147 with more inspection advice, including a new section on external inspection.
Lessonkeeping an old tank in service rests on evidence from its own record and from tanks like it.
Credit
ADGAS (A. S. Adamou); EEMUA
2023
Tanks reach 270,000 m³
Sinopec put a 270,000 m³ LNG tank, 100.6 m across and 55 m high, into service at its Qingdao terminal on 2 November 2023, and called it the world's largest. KOGAS is building four tanks of the same size at a new terminal at Dangjin, South Korea, whose roofs were all completed in August 2024, according to GIIGNL.
Credit
Sinopec
Watch for
Thirteen years without accident
IHI Plant Services and Shimizu say Tokyo Gas has run the 250,000 m³ in-ground tank at Ohgishima safely and without accident since 2013, and that its technologies have proven reliable in operation.
Achieved whenTokyo Gas or Japan's regulator publishes inspection or operating results for the tank that an outside engineer can check.
Claimed by
IHI Plant Services and Shimizu, April 2026
Open
01
List every LNG tank
A public world list of LNG storage tanks, one row per tank: site, capacity, containment type (single, double, full containment, membrane or in-ground), inner tank material, builder and year in service, each row linked to a source. Then publish the age profile: how many tanks will pass 40 and 50 years in service by 2035.
The briefCredit · unclaimed02
Measure tank settlement from space
A public table and map of how fast the ground under each LNG storage tank in Europe is sinking or tilting, in millimeters a year, read from radar satellite measurements. Tanks are heavy and most terminals stand on the coast, so owners survey whether the ground under each tank is sinking evenly; those surveys are not public.
The briefCredit · unclaimed
Open 01 · the brief
List every LNG tank
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public world list of LNG storage tanks, one row per tank: site, capacity, containment type (single, double, full containment, membrane or in-ground), inner tank material, builder and year in service, each row linked to a source. Then publish the age profile: how many tanks will pass 40 and 50 years in service by 2035.
Why it is still open
GIIGNL's annual report lists, for each plant and terminal, the number of tanks and their total capacity, but not each tank's type, material or year. Tanks from the 1980s are already reaching their design life. No public tank-by-tank list was found.
Built with what exists
GIIGNL annual reports; builders' published reference lists, such as CB&I's (more than 220 LNG tanks, by its count) and IHI Plant Services' (37 in-ground tanks); terminal owners' reports; AI models that read documents and pull out figures (see the Note "The jobs agents repeat"); a spreadsheet.
First step
Enter Japan's terminals from GIIGNL's 2026 report and match their tanks to IHI Plant Services' and other builders' reference lists.
Done looks like
Every site in GIIGNL's 2026 report covered; the tank count matches GIIGNL's for at least 95% of sites; type and year in service filled in, with a source, for at least 80% of tanks; a second person rechecks 100 rows and agrees on at least 95%.
Open 02 · the brief
Measure tank settlement from space
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public table and map of how fast the ground under each LNG storage tank in Europe is sinking or tilting, in millimeters a year, read from radar satellite measurements. Tanks are heavy and most terminals stand on the coast, so owners survey whether the ground under each tank is sinking evenly; those surveys are not public.
Why it is still open
Radar interferometry, which compares repeated radar images to measure ground movement of a few millimeters, has been applied to single LNG tanks: Ming Guo and colleagues combined 37 Sentinel-1 images from 2020 to 2023 with laser scans of one unnamed island tank in China. The European Ground Motion Service now publishes such measurements for all of Europe, updated every year and free to download. Searches found no survey that compares the tanks of many terminals.
Built with what exists
Downloads from the EGMS Explorer; terminal locations from the LNG-T3 dataset or Gas Infrastructure Europe; tank outlines traced from free aerial or satellite images; QGIS and Python.
First step
Download the EGMS measurement points around one terminal, such as Zeebrugge in Belgium, and count how many fall on each tank roof.
Done looks like
A yearly settlement rate, with its uncertainty, for every tank at at least 15 European terminals; the difference in rate across each tank as a measure of tilt; a second analyst repeats five terminals from the raw downloads and gets rates within 1 mm a year; code and table published.