BRENNEN

Industries / Food, farming and forestry / Agriculture and farming / Irrigation

Drip and micro-irrigation

Drip and micro-irrigation feed water slowly to each plant through emitters set in plastic tubes laid on, above or under the soil, often with fertilizer mixed into the water.

6

Milestones achieved, from 1989 to 2024.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1989

    Drip goes under the corn

    In March 1989 Kansas State University buried driplines at its Colby research center to test subsurface drip irrigation (SDI) on corn, a crop thought too cheap to pay for drip. Careful management cut the irrigation the corn needed by nearly 25% while keeping yields near 200 bushels an acre (about 12.5 tonnes a hectare), by Lamm and colleagues' 1995 results. One block grew corn for 27 seasons without new driplines: its plot flow rates stayed within ±5% of their first measured values, and it was retired in the fall of 2015 because the plastic began to leak, not because emitters clogged.

    LessonBuried drip can last a quarter century when it is filtered and maintained, and that life is what lets it compete with center pivots on a crop like corn.

    mountainscholar.orgagris.fao.org

    Credit

    Freddie Lamm, Danny Rogers and colleagues, K-State Research and Extension

  2. 1996

    Drip under plastic in Xinjiang

    Farmers in Xinjiang, China's largest cotton region, had spread plastic film over their fields since 1980 to keep heat and water in the soil. From 1996 to 1998 the Xinjiang Production and Construction Corps, a state farming organization, ran successful trials at Shihezi of drip tape laid under the film. A 2025 preprint, citing official figures, puts drip under film at 12.2% of Xinjiang's irrigated area in 2008, 30.1% in 2011 and 56.7% at the end of 2018; machines now sow, lay the tape and spread the film in one pass.

    LessonThe thin film is hard to collect after harvest: a 2020 study put recovery at only 60% to 85% and found cotton yields fell once leftover film in the soil passed about 200 kg a hectare.

    researchsquare.comijabe.org

    Credit

    Xinjiang Production and Construction Corps

  3. 2005

    Cheap drip kits left idle

    Low-head drip kits, a bucket or drum raised about 1 m to feed a few drip lines, were promoted to Kenyan smallholders from the late 1990s. In a 2002 survey, I. K. Kulecho and E. K. Weatherhead found that most farmers who gave up did so for lack of maintenance, unreliable water, or a kit that did not fit how they farmed; reviewers later reported that 78% of the Kenyan adopters interviewed had stopped within two years, and that Belder and colleagues (2007) found 62.8% of Zimbabwean users abandoning kits within one or two years. In 2009 and 2010 interviews in Ethiopia, Malawi, Senegal and Zambia, 20% of farmers who had stopped said taking the system up, storing it and putting it back each rainy season was too hard or took too long.

    LessonA cheap kit spreads only where the farmer can store water, get spare parts and keep it running.

    link.springer.comsocial-sciences.tau.ac.il

    Credit

    Kulecho and Weatherhead (2005); Lonia Friedlander, Alon Tal and Naftali Lazarovitch (2013)

  4. 2015

    India pays for drip

    India's Per Drop More Crop scheme, started in 2015–16 within the Pradhan Mantri Krishi Sinchayee Yojana, pays 55% of the cost of a drip or sprinkler system for small and marginal farmers and 45% for others, on up to 5 ha each, and states add subsidies of their own. By July 2026 the government counted 115 lakh ha (11.5 million ha) brought under micro-irrigation, about 8.11% of India's net sown area.

    static.pib.gov.in

    Credit

    India's Ministry of Agriculture and Farmers Welfare

  5. 2019

    Late subsidies sink a dripmaker

    Jain Irrigation Systems, an Indian maker of drip systems and plastic pipes, had to wait on state governments for subsidy payments on the systems it sold. On 30 June 2019 its lenders invoked a debt resolution, triggered, the company said, by delays in debt servicing caused by "extended working capital cycles due to delay in receipts from governments"; debt of Rs 3,878 crore (about 39 billion rupees) was restructured in March 2022. The credit rater ICRA later noted that overdue receivables were being recovered more slowly than the plan assumed.

    LessonWhen the state pays most of a farmer's system, the maker's cash depends on how fast the state pays.

    business-standard.comicra.in

    Credit

    Jain Irrigation Systems; lenders led by State Bank of India

  6. 2024

    Gravity drip clogs by midseason

    N-Drip sells drip systems that run from a tank or channel by gravity alone, without the pumps or filters of pressurized drip. University of Arizona extension tested its systems on three cotton fields in 2024. At the Maricopa Agricultural Center, distribution uniformity (the flow of the lowest quarter of emitters as a share of the average) fell from 78.1% in May, rated good, to 45.8% in July and 38.9% in September, rated unacceptable, as clogging cut the average emitter flow by 39%. The report recommends acid and chlorine treatments and says "further investigation is needed to identify the most effective protocol."

    LessonLow pressure saves pumping but leaves too little push to keep emitters clear, so a gravity system needs its own cleaning routine.

    extension.arizona.edu

    Credit

    Diaa Eldin Elshikha (University of Arizona Cooperative Extension)

Watch for

  1. Low-pressure emitters that resist clogging

    Researchers at MIT's GEAR Lab, with engineers from the Toro Company, designed compact pressure-compensating emitters, which hold their flow steady once the line reaches a set pressure, with a reshaped internal channel that lets particles through. They report that in field tests the emitters kept 90% to 94% of their starting flow and were as reliable as, or more reliable than, some commercial emitters, while working at 15% to 65% lower pressure.

    Achieved whenthe emitters are on sale and an outside laboratory or university measures their flow and clogging over at least one full season.

    gear.mit.edu

    Claimed by

    Aditya Ghodgaonkar, Amos Winter and colleagues (MIT and Toro), in Water, June 2026

Open

  1. 01

    Cleaning routines for gravity drip

    A season-long bench test of cleaning routines for drip lines fed by gravity from a tank about 1 to 1.5 m above them, run on hard well water. Compare plain flushing of the line ends, citric acid, chlorine, and acid pushed through by a small pump, each on its own set of lines, and measure every emitter's flow each week.

    The brief
    Credit · unclaimed
  2. 02

    Drip kits that pack away

    A smallholder drip kit for about 100 m² that one person can take up, store and lay out again in under 30 minutes, and a public test showing that it still waters evenly after 20 such cycles.

    The brief
    Credit · unclaimed

Open 01 · the brief

Cleaning routines for gravity drip

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A season-long bench test of cleaning routines for drip lines fed by gravity from a tank about 1 to 1.5 m above them, run on hard well water. Compare plain flushing of the line ends, citric acid, chlorine, and acid pushed through by a small pump, each on its own set of lines, and measure every emitter's flow each week.

Why it is still open

The University of Arizona's 2024 test of gravity drip on cotton recommended acid and chlorine treatments but found that "further investigation is needed to identify the most effective protocol", and warned that the low pressure of gravity systems may make treatments less effective. No published test of cleaning routines on gravity-fed lines was found.

extension.arizona.edu

Built with what exists

200 L tanks on stands; gravity drip lines from two makers; a small 12 V pump for the pumped-acid set; food-grade citric acid and household chlorine bleach, used on different days and never mixed; catch cups, a kitchen scale and a phone timer, or load cells read by a small microcontroller board to weigh the cups automatically.

  1. First step

    Set up two tanks and four lines this month, half cleaned and half left alone, and weigh every emitter's output once a week.

  2. Done looks like

    Six routines, each on three lines of 50 emitters, run for 20 weeks on the same water, with weekly distribution uniformity and mean flow published for each routine against an untreated control, and the water's hardness and iron recorded.

Open 02 · the brief

Drip kits that pack away

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A smallholder drip kit for about 100 m² that one person can take up, store and lay out again in under 30 minutes, and a public test showing that it still waters evenly after 20 such cycles.

Why it is still open

In interviews in four African countries, 20% of farmers who had given up drip said taking the system up, storing it and reinstalling it each rainy season was too hard or took too long, and the authors asked promoters to "redesign drip systems to help prevent common problems". No kit tested for repeated take-up and reinstallation was found.

social-sciences.tau.ac.il

Built with what exists

Thick-walled drip line; a hand-cranked hose reel, or one built from a bicycle wheel; push-fit quick connectors; a 200 L drum raised 1 m; catch cups and a scale to measure distribution uniformity; a phone to time and film each cycle.

  1. First step

    Lay one 100 m² kit on a reel this month and time five take-up and lay-out cycles.

  2. Done looks like

    Three prototypes, each taken up and laid out 20 times by five different people, with the time for each cycle, leaks and broken parts logged, and distribution uniformity measured before and after, at least 75% after the 20th cycle, with designs and data released.