Industries / Transport and vehicles / Automotive / Auto repair
Routine service and inspection
Routine service is the regular care that keeps a car safe and legal, such as oil changes, brakes, tires and air conditioning, together with the periodic inspections that many countries require.
6
Milestones achieved, from 1960 to 2022.
1
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
The road
AchievedWatch forOpen
Achieved
1960
Older cars face a test
In September 1960 Britain's Ministry of Transport began the MOT test, which was obligatory for vehicles registered more than 10 years earlier. It checked only brakes, steering, lights and reflectors. A test cost 15 shillings for a car, and a car that failed could be repaired and retested at a reduced fee within 14 days, by Autocar's report of the time. The test was later extended to younger cars; most vehicles in Great Britain now need one every year from three years old.
Credit
UK Ministry of Transport, under Ernest Marples
1992
Refrigerant must be recovered
Section 609 of the US Clean Air Act, added on 15 November 1990, required that from 1 January 1992 anyone paid to service a car's air conditioner use approved equipment that recovers and recycles the refrigerant, and be trained and certified to use it. Shops that had serviced fewer than 100 air conditioners in 1990 had until 1 January 1993. The equipment and training had to meet at least the SAE standards J1990 and J1989, through programs such as those of ASE and the Mobile Air Conditioning Society. EPA still approves the programs that certify technicians.
Credit
US Congress; US Environmental Protection Agency (EPA); SAE International
1998
The car says when
Oil was changed by the odometer or the calendar: by GM's account the usual advice was every 3,000 miles or three months for short trips in freezing weather, and up to 7,500 miles for long, mild trips. Shirley Schwartz and Donald Smolenski of the GM Research Laboratories built a model that estimates how much life is left in the oil from engine revolutions and oil temperature, published as SAE paper 870403 in 1987. In November 1998 General Motors said its Oil-Life System would go on 90% of its production over five years, starting with its 1999 full-size pickups, and would allow 10,000 to 15,000 miles between changes on some 2000 models. GM calculated that one year's equipped vehicles would produce about 40 million quarts less waste oil a year.
Credit
Shirley Schwartz and Donald Smolenski, General Motors
2002
Inspections plug into the car
US emissions inspection programs, called I/M (inspection and maintenance), tested cars by measuring their exhaust. An EPA rule of 5 April 2001 required those programs to check the on-board diagnostic (OBD) computer of 1996 and newer cars from 1 January 2002, and let states drop the traditional tests on those cars once they were checked through OBD. The inspector reads the faults the car has recorded about its own emissions controls.
Credit
US EPA, Office of Transportation and Air Quality
2015
Copper out of brake pads
Dust from braking washes copper into streams, where it can harm fish, amphibians and plants. After Washington and California passed laws limiting copper in brake pads, EPA, the Environmental Council of the States and eight industry groups signed an agreement on 21 January 2015 to cut copper in pads sold across the US to under 5% by weight in 2021 and 0.5% by 2025, with marks on the packaging. EPA says estimates for California show up to a 61% fall in copper in urban runoff from the change in pads.
Credit
US EPA; the Motor and Equipment Manufacturers Association, the Auto Care Association, the Brake Manufacturers Council and the other signatories
2022
Inspectors count exhaust particles
A diesel particulate filter (DPF) traps soot in the exhaust, but filters fail, and some are removed illegally. Belgium began counting particles in the exhaust at periodic inspection in July 2022, the first European country to do so by DieselNet's account, and the Netherlands and Switzerland followed on 1 January 2023. About 6,000 Dutch inspection garages bought counters that measure at idle. A Dutch car fails above 1,000,000 particles per cubic centimeter, a limit relaxed from 250,000 in a political compromise. In Flanders results analyzed by Abeelen APK and ETS, about 10% of 10-year-old cars were rejected, a share that rose sharply in older cars.
LessonThe check became law only after a counter fast and cheap enough for ordinary garages had been developed; the first one was approved in the Netherlands in 2020.
Credit
the N-PTI working group, with TNO and NMi; the Belgian, Dutch and Swiss authorities
Watch for
Particle tests across the EU
On 24 April 2025 the European Commission proposed revising the EU's rules for periodic inspection, Directive 2014/45, with new test methods for particles and nitrogen oxides, yearly tests for cars over 10 years old, and checks of electric cars and driver-assistance systems. On 4 December 2025 transport ministers set the Council's position: they dropped the yearly tests for older cars but kept the new particle and nitrogen oxide test methods. In May 2026 the European Parliament's transport committee also declined yearly tests, by the account of the road safety group ETSC, and Parliament then entered negotiations with the Council.
Achieved whenThe revised directive is published in the EU's Official Journal and requires particle counting at periodic inspection of diesel cars in every member state.
Claimed by
European Commission, April 2025; Council of the EU, December 2025
Open
01
Which MOT warnings come true
For each kind of MOT advisory, the note a tester writes about wear that does not yet fail the test, such as "brake pad(s) wearing thin", a table of how often the same item fails at the car's next test, and after how many miles, by make, model and age. Publish the table and the code.
The briefCredit · unclaimed02
Brake pads measured by camera
A public test of measuring the brake pad lining that is left from a photo taken through the wheel, without taking the wheel off, and an open model scored on it.
The briefCredit · unclaimed
Open 01 · the brief
Which MOT warnings come true
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
For each kind of MOT advisory, the note a tester writes about wear that does not yet fail the test, such as "brake pad(s) wearing thin", a table of how often the same item fails at the car's next test, and after how many miles, by make, model and age. Publish the table and the code.
Why it is still open
The UK publishes every MOT test since 2005, with each failure and advisory item, and a vehicle identifier that links tests of the same car over time. Public projects that use the data predict whether a whole test will pass, such as a student project begun in November 2026, or list a car's past advisories for buyers. TyreSafe, a UK tyre-safety charity, has done the count for one item on one kind of vehicle: of nearly 27,600 vans given a tyre advisory in February 2024, 7.0% had a dangerous tyre defect at their next test, against 3.6% of vans without one. No table for every advisory item, or for cars, was found.
Built with what exists
The anonymised MOT data from the Department for Transport (2005 to 2022) and DVSA (2023 on), with its user guide; DuckDB and Python; a survival model, such as the lifelines library, for miles to failure; an AI model to group the free-text advisories that testers type, checked by hand on a sample.
First step
Download the 2023 and 2024 result and item files, link tests by vehicle identifier, and compute the rate for brake pads.
Done looks like
For the 50 most common advisory items, the share that fail at the next test and the median miles to failure, from at least five years of tests after the May 2018 change in defect categories, with confidence intervals, published as open data; the same code reproduces DVSA's published initial failure rate for one year to within 0.5 percentage points.
Open 02 · the brief
Brake pads measured by camera
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public test of measuring the brake pad lining that is left from a photo taken through the wheel, without taking the wheel off, and an open model scored on it.
Why it is still open
Patents granted to Nissan in October 2024 and to Valvoline in June 2026 describe estimating pad thickness from a camera or probe image without removing the wheel, but no published accuracy figures or open image set were found, and a GitHub search for brake pad thickness and wear detection found none.
Built with what exists
A phone and a USB borescope camera; a digital caliper for the true thickness; Label Studio to mark lining and backing plate; a small vision model that can be fine-tuned on one graphics chip, such as Liquid AI's LFM3 (see the Note "One GPU to fine-tune"), or an Ultralytics YOLO segmentation model.
First step
Ask a local shop for 50 worn pads from its scrap bin, measure each at three points, and photograph each from three angles through a spare wheel.
Done looks like
1,000 photos of at least 200 pads, each with a caliper-measured thickness; a model with a mean error of 0.5 mm or less on pads it was not trained on; and a second score on 50 pads photographed on cars by shop staff during routine inspections.