Industries / Food, farming and forestry / Food and beverage processing / Soft drink bottling
Water and energy use
Water and energy use is the work of managing the water a bottling plant draws, uses and sends back, and the fuel and electricity used by the plant and by the coolers that chill its drinks in shops.
4
Milestones achieved, from 2004 to 2021.
1
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
The road
AchievedWatch forOpen
Achieved
2004
A plant shut over groundwater
Hindustan Coca-Cola Beverages opened a bottling plant at Plachimada in Kerala, India, in March 2000 and shut it in March 2004, after local protests, a refusal by the Perumatty village council to renew its licence because groundwater use was blamed for drinking-water shortages, and a state order banning it from drawing groundwater during drought. In December 2003 a single judge of the Kerala High Court held that groundwater was public property held in trust. In April 2005 a division bench of the same court reversed that, on the report of an expert committee led by the Centre for Water Resources Development and Management. The committee found low rainfall was the main cause of the shortage, made worse by unregulated pumping, and said the plant could draw 500,000 litres a day in years of normal rainfall but must cut back in dry years.
Lessonthe court tied the plant's allowed pumping to each year's monsoon, a rule that links a bottler's output to local rainfall.
Credit
Perumatty Grama Panchayat; High Court of Kerala; the CWRDM-led committee
2014
A million HFC-free coolers
Hydrofluorocarbons (HFCs) are refrigerant gases that warm the climate strongly when they leak. Through Refrigerants, Naturally, a group of Coca-Cola, PepsiCo and Unilever supported by the UN Environment Programme and Greenpeace, drink companies set out to move shop coolers to natural refrigerants. In February 2014 Coca-Cola said it had installed its millionth HFC-free cooler and set a goal that all new cold-drink equipment would be HFC-free by 2015. The International Institute of Refrigeration reported in 2023, from company reports, that 61% of Coca-Cola's new coolers were HFC-free in 2016 and 88% in 2022, and that the industry moved from carbon dioxide as the refrigerant to hydrocarbons such as propane.
Lessonthe 2015 goal was missed, and the refrigerant first chosen for millions of coolers was replaced within a few years.
Credit
Refrigerants, Naturally members, with UNEP and Greenpeace; The Coca-Cola Company
2016
Replenished, but elsewhere
In 2007 Coca-Cola set a goal to "replenish", or return to nature and communities, as much water as it used in its drinks. In August 2016 it said it had returned almost 192 billion litres in 2015, 115% of the water in its drinks, in a report audited by LimnoTech and Deloitte with a method made with The Nature Conservancy. Reporting on the 2014 figure, HuffPost found that the projects counted included grassland restoration in North Texas, reforestation in Ghana and canal repairs in Kyrgyzstan, that the company's water director said the water replenished "isn't directly the water we extract from", and that Coca-Cola paid both reviewers.
Lessona global total can pass 100% while the aquifer under a given plant is still drawn down, so a water claim needs to be counted basin by basin.
Credit
The Coca-Cola Company; The Nature Conservancy (method); LimnoTech and Deloitte (review)
2021
Energy rules for drink coolers
From 1 March 2021, EU Regulation 2019/2024 set minimum energy performance for refrigerated appliances that sell directly to customers, including beverage coolers, ice-cream freezers, supermarket cabinets and refrigerated vending machines, alongside a separate regulation giving them energy labels. The European Commission estimated that these appliances used 65 TWh of electricity in the EU in 2015 and that the rules could save 48 TWh a year by 2030.
Credit
European Commission
Watch for
Replenishing each risky basin
Coca-Cola now counts replenishment site by site in more than 200 high-risk locations, picked with the World Resources Institute's Aqueduct 4.0 water-risk tool, and counts only projects in the same local basin or water-supply catchment. It reports that in 2025 it returned 160% of the water in its drinks globally, but that only 34% of its high-risk locations each met 100%. It aims for all of them by 2035. It also reports using 1.77 litres of water per litre of drink in 2025, against 1.98 in 2015.
Achieved whenthe site-level results are checked by an outside party and published by basin, so each high-risk plant's balance can be checked.
Claimed by
The Coca-Cola Company, August 2026
Open
01
Shop coolers metered in heat
A month-long field study that meters glass-door drink coolers in small shops in a hot country, logging electricity use, door openings, inside and room temperature and power cuts, and publishes the data against the coolers' rated figures.
The briefCredit · unclaimed02
Public map of risky plants
An open map of soft drink bottling plants, starting with the Coca-Cola system and PepsiCo's bottlers, each placed on Aqueduct 4.0's water-stress layer, so that companies' counts of high-risk plants and their basin-by-basin water claims can be checked.
The briefCredit · unclaimed
Open 01 · the brief
Shop coolers metered in heat
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A month-long field study that meters glass-door drink coolers in small shops in a hot country, logging electricity use, door openings, inside and room temperature and power cuts, and publishes the data against the coolers' rated figures.
Why it is still open
Energy figures for coolers come mostly from laboratory tests at fixed conditions. A 2010 Danish Technological Institute report says typical impulse coolers in Danish shops use about 5 to 8 kWh a day, measures prototypes in the laboratory, and mentions a Danish field test of 18 bottle coolers with Carlsberg. Coca-Cola says refrigeration is about a third of its carbon footprint, as the International Institute of Refrigeration reports. Searches for this file, GitHub included, found no published field data for drink coolers in small shops in hot countries.
Built with what exists
Plug-in energy meters that log over Wi-Fi or mobile data (Shelly plugs, or plugs flashed with the open Tasmota firmware), magnetic door switches and temperature probes on an ESP32 board, a SIM data plan, and Python for the analysis. Only plug-in coolers are used, so no wiring work is needed.
First step
Ask five shopkeepers in one city for permission, fit meters and loggers to their coolers for one week, and check how much data is lost during power cuts.
Done looks like
At least 30 coolers in at least 10 shops logged for 28 days, reported as kWh per day, per litre of cooler volume and per door opening, against the label or nameplate figure, with gaps from power cuts counted. The dataset and code are public.
Open 02 · the brief
Public map of risky plants
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
An open map of soft drink bottling plants, starting with the Coca-Cola system and PepsiCo's bottlers, each placed on Aqueduct 4.0's water-stress layer, so that companies' counts of high-risk plants and their basin-by-basin water claims can be checked.
Why it is still open
Coca-Cola says it identified more than 200 high-risk locations with Aqueduct 4.0 and its own plant assessments, and that 34% met their replenishment target in 2025, but its 2025 update gives counts and percentages, not a list of sites. Climate TRACE, which maps emitting sites worldwide, names only a handful of soft drink bottling plants among the first 3,000 food, drink and tobacco sites in its public list, checked for this file. No independent plant-by-plant map turned up in web or GitHub searches.
Built with what exists
Aqueduct 4.0 data from the World Resources Institute (free to download), plant addresses from bottlers' own websites and OpenStreetMap, GeoPandas or QGIS, and a web-browsing AI agent to collect and cite addresses, with each one checked by a person. Small models such as Meta's Muse Ember suit this kind of extraction (see the Note "The jobs agents repeat").
First step
Collect plant addresses for one large bottler, such as Coca-Cola FEMSA or Coca-Cola HBC, from its own website, place them on Aqueduct, and compare the result with any high-risk sites that bottler names.
Done looks like
At least 500 plants from at least 10 large bottlers placed with a cited source, each scored for baseline water stress, and the count of plants in high or extremely high stress compared with the companies' own figures. All data public, with a stated error rate from a hand check of 50 plants.