BRENNEN

Industries / Mining and materials / Pulp and paper

Energy and water

Making pulp and paper takes large amounts of heat, power and water; this work covers how mills make their own energy, cut fossil fuel, and clean the water they return.

4

Milestones achieved, from 1992 to 2022.

2

To watch for: announced, not yet confirmed outside.

1

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1992

    A pulp mill with no effluent

    Millar Western's mill at Meadow Lake, Saskatchewan, which makes bleached chemi-thermo-mechanical pulp (wood softened with chemicals and then ground), began operating in 1992. It cleans and reuses its process water instead of discharging it, and the Encyclopedia of Saskatchewan calls it the first mill in the world not to discharge effluent into any nearby water body.

    esask.uregina.ca

    Credit

    Millar Western, with the Crown Investments Corporation of Saskatchewan

  2. 1998

    Dioxin limits change bleaching

    The US Environmental Protection Agency's Cluster Rule, final on 15 April 1998, set water and air limits for pulp and paper mills. For bleaching mills it requires the dioxin TCDD in wastewater to be below the analytical minimum level of 10 parts per quadrillion, which calls for reduced use of elemental chlorine and hypochlorite, or bleaching with chlorine dioxide or other chemicals.

    epa.govgovinfo.gov

    Credit

    US Environmental Protection Agency

  3. 2017

    A mill that exports power

    Metsä Fibre's bioproduct mill at Äänekoski, Finland, started in 2017 with capacity for 800,000 tonnes of softwood and 500,000 tonnes of hardwood pulp a year. By Metsä's figures it makes 240% of the electricity it uses, burns no fossil fuels, gasifies bark for fuel, and sends its surplus electricity to the grid.

    metsagroup.commetsagroup.com

    Credit

    Metsä Fibre

  4. 2022

    Energy prices stop machines

    European paper and board production fell 6.1% in 2022, a larger drop than the 4.7% of the 2020 pandemic year. Cepi says record energy prices forced temporary machine stops in the second half of the year, and that record electricity, gas and CO2 prices hit recycling mills hardest, with use of paper for recycling down 6.4%.

    LessonEnergy prices alone can idle paper machines, and recycling mills felt it most.

    cepi.org

    Credit

    Cepi statistics

Watch for

  1. Steam from a heat pump

    Turboden says the heat pump it built for delfort's specialty paper mill makes 12 MW of superheated steam at 3.4 bar from waste heat, is the largest steam-producing heat pump ever built, and runs with a coefficient of performance (heat delivered per unit of electricity) 10% higher than expected. It avoids about 19,000 tonnes of CO2 a year, a figure the European Heat Pump Association repeats for a Finnish paper factory.

    Achieved whenthe mill or an independent party publishes a year of metered steam output and electricity use.

    turbomachinerymag.comehpa.org

    Claimed by

    Turboden, February 2026

  2. A year of monitoring in Italy

    A high-temperature heat pump combined with mechanical vapour recompression was commissioned at the Cartiere di Guarcino paper mill in Italy in late 2025 and has entered a one-year monitoring phase. The project says it could save about 817 tonnes of CO2 a year against a gas boiler.

    Achieved whenthe monitoring results are published with measured energy use.

    ehpa.org

    Claimed by

    the European Heat Pump Association, reporting on the EU-funded Push2Heat project, May 2026

Open

  1. 01

    A mill-by-mill heat pump screen

    An open list of Europe's paper and pulp mills that estimates, for each mill, how much of its steam an industrial heat pump could supply, with the method and code published.

    The brief
    Credit · unclaimed

Open 01 · the brief

A mill-by-mill heat pump screen

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An open list of Europe's paper and pulp mills that estimates, for each mill, how much of its steam an industrial heat pump could supply, with the method and code published.

Why it is still open

The main EU estimate, by TNO in 2021, works from generic processes and sector totals; it puts the paper sector's heat pump potential at 7.9 GW of heating capacity but does not rank individual mills, and its authors call their figures conservative. Large steam heat pumps at paper mills only began reporting results in 2026.

publications.tno.nlturbomachinerymag.com

Built with what exists

The EU Emissions Trading System's public data on each installation; company sustainability reports and permits; Python; a language model that pulls steam and production figures out of those documents, checked by hand (Note: "Seven more flagged").

  1. First step

    Download the latest EU Emissions Trading System installation list, filter it to the pulp and paper activities, and match ten mills to their public reports.

  2. Done looks like

    At least 300 EU mills listed, each figure tied to a source. The method is tested on at least three mills with published heat pump projects, such as delfort and Cartiere di Guarcino, and its estimate falls within 25% of the steam those projects report.