BRENNEN

Industries / Media, arts and recreation / Media and entertainment / Movie theaters

Projection and sound

Projection and sound is the work of putting a bright, steady picture on the screen and playing the soundtrack at the level the film was mixed for, from the projection booth and the auditorium's speakers.

7

Milestones achieved, from 1929 to 2017.

2

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1929

    Smoke panics a children's matinee

    On 31 December 1929, during a children's matinee at the Glen Cinema in Paisley, Scotland, a metal box holding nitrate film, a highly flammable film base, began to smoke after it was put on top of a battery in the projection room, the later inquiry concluded. There was no fire, but children ran for exits that were padlocked and whose doors opened inward, and 71 died in the crush, by the BBC's count.

    LessonThe UK amended the Cinematograph Act 1909 so that cinemas had more exits and escape doors with push bars that opened outwards.

    bbc.co.uk

    Credit

    The Glen Cinema, Paisley; the official inquiry that followed

  2. 1948

    Safety film replaces nitrate

    In 1948 Kodak announced a 35 mm film on a triacetate base, a far less flammable plastic, to replace cellulose nitrate in motion pictures; the changeover took about four years, and Kodak's chronology marks it complete in 1952. Under nitrate, UK rules had required a separate rewind room, a large team of projectionists and reels of no more than 20 minutes, so a feature ran on two projectors with a "change-over" from one to the other at the end of each reel; with nitrate gone, the limits on reel length were relaxed, by the University of Warwick's history of the projection box.

    kodak.comnavy-rail.lnx.warwick.ac.uknavy-rail.lnx.warwick.ac.uk

    Credit

    Eastman Kodak, which lists an Academy Scientific or Technical Award for its improved safety film under 1949

  3. 1970s

    One projector runs the show

    A carbon-arc lamp, the usual light source since the early days, burned through its carbon rod in under an hour, while the xenon-arc lamps that appeared in the late 1960s could burn for more than 5,000 hours, so a whole programme of ads, shorts and feature could run through a single projector, by the account of the Australian journal Cinema Record. Platters, large turntables that hold a whole film flat beside the projector, spread in the late 1970s; together with automation cues stuck to the film to work the lights and curtains, they let one projectionist run several screens at once, which helped the multiplex spread.

    LessonBooths that ran themselves gave owners a reason to understaff them, so a film spilling onto the floor or another fault could go unnoticed, as the film-handling guide Sprocket School records.

    cinemarecord.org.ausprocketschool.orgnavy-rail.lnx.warwick.ac.uk

    Credit

    The makers of xenon lamps and platters; early adopters such as Hoyts, which put platters in its city cinemas in the mid-1970s

  4. 1977

    Four channels from two tracks

    Dolby Stereo put two optical sound tracks in the space of the standard mono track on an ordinary 35 mm print and coded four channels into them, three behind the screen and one for surround speakers, with Dolby noise reduction, at a fraction of the cost of magnetic sound on 70 mm prints. Dolby's timeline dates the first general release to 1975, Ken Russell's Lisztomania; Star Wars and Close Encounters of the Third Kind, both in Dolby Stereo in 1977, gave cinemas the push to upgrade their sound equipment, by The Register's account.

    theregister.comprofessional.dolby.com

    Credit

    Dolby Laboratories, which received an Academy Scientific and Engineering Award for the system in 1979

  5. 1992

    Digital sound keeps a backup

    Kodak and Optical Radiation Corporation's CDS digital soundtrack opened with Dick Tracy in June 1990, but its data took the place of the analog track, so any fault in the reader left the audience with no sound at all; with conversion costing nearly $20,000 a theater, it ended after nine films. Dolby Digital, which opened with Batman Returns in 1992, kept the analog track and printed its data between the sprocket holes; DTS, first used on Jurassic Park in June 1993, printed only a timecode on the film and played the sound from discs; Sony's SDDS, from Last Action Hero in 1993, used the outer edges of the film, and Sony stopped making it in 2004.

    LessonThe format with no fallback failed, and the three that lasted all left an analog track on the print for when the digital data could not be read.

    local695.com

    Credit

    Dolby Laboratories; Terry Beard and DTS; Sony; Kodak and ORC

  6. 1999

    Films shown from files

    In June 1999 Star Wars: Episode I – The Phantom Menace played from digital files to paying audiences in four US cinemas, two near Los Angeles and two in northern New Jersey, on Texas Instruments DLP and Hughes-JVC projectors; Miramax's An Ideal Husband opened digitally the same day, perhaps an hour earlier, by The Hollywood Reporter's account. The Christian Science Monitor found audiences divided. Texas Instruments went on to license its DLP chip to the projector makers Barco, Christie and NEC, while the Hughes-JVC projector did not last.

    LessonThere were no technical standards for digital cinema in 1999, and early digital releases were mastered on Panasonic's D5 videotape, so a common specification had to be written afterwards.

    hollywoodreporter.comcsmonitor.com

    Credit

    Lucasfilm; Texas Instruments; Hughes-JVC; Miramax

  7. 2017

    Screens that make their light

    In July 2017 Samsung announced a cinema screen made of LED panels, which give off their own light so no projector is needed, at Lotte Cinema World Tower in Seoul: 10.3 m wide, 4K resolution and a peak brightness of 146 foot-lamberts, nearly ten times standard projection by Samsung's figures. Samsung says it was the first product to pass the full Digital Cinema Initiatives (DCI) compliance tests, in May 2017. By 2026 such screens were in cinemas in North America, Europe, the Middle East and Asia, including six at the Pathé Palace in Paris, Boxoffice Pro reported.

    LessonA solid LED wall leaves no room for the speakers that sit behind a perforated projection screen, and a supplier told Boxoffice Pro in 2026 that sound has been one of the main barriers to wider use.

    news.samsung.comboxofficepro.com

    Credit

    Samsung Electronics; Lotte Cinema

Watch for

  1. Speakers behind LED screens

    Makers are fitting LED cinema screens with perforated, "acoustically transparent" panels so the speakers can stay behind the picture, as they do with projection; Tricorne Premium LED and GDC Technology have installed one at Odeon Multicines Sambil in Madrid, and Digital Light Sources is building another with Cine LEDMAX.

    Achieved whenan independent acoustician publishes measurements of sound through such a screen compared with the same speakers behind a standard perforated projection screen.

    boxofficepro.com

    Claimed by

    the makers, as reported by Boxoffice Pro, August 2026

  2. A comfort limit for loudness

    Charles Q. Robinson writes in the SMPTE Motion Imaging Journal that, more than 25 years after Ioan Allen of Dolby asked in a paper whether movies are too loud, cinemas still play films below the reference level they were mixed at and trailers are still too loud, despite the Trailer Audio Standards Association (TASA) limit. He proposes a "Comfort Threshold" for features and trailers, set from measured audience satisfaction, and changes to current practice.

    Achieved whenSMPTE or TASA adopts the threshold and measurements in ordinary cinemas show features played at the reference level.

    journal.smpte.org

    Claimed by

    Charles Q. Robinson, May 2025

Open

  1. 01

    Measure screen brightness from seats

    A public table of measured brightness for at least 50 ordinary cinema screens. With the manager's permission, the cinema plays a white test picture before opening, and the luminance of the screen (the brightness of the light coming off it) is read at the centre and four outer points from the seat the SMPTE standard names, with the screen's light source (xenon lamp, laser or LED) recorded.

    The brief
    Credit · unclaimed
  2. 02

    Log how loud shows play

    A public log of sound levels at 100 ordinary paid screenings in at least five cinema chains. From a central seat, a sound level meter logs A- and C-weighted levels every second through the trailers and the feature. It records levels only, never the sound itself, so nothing of the film is copied. Each screening is published with its trailer and feature averages, and the same film is measured in several cinemas.

    The brief
    Credit · unclaimed

Open 01 · the brief

Measure screen brightness from seats

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public table of measured brightness for at least 50 ordinary cinema screens. With the manager's permission, the cinema plays a white test picture before opening, and the luminance of the screen (the brightness of the light coming off it) is read at the centre and four outer points from the seat the SMPTE standard names, with the screen's light source (xenon lamp, laser or LED) recorded.

Why it is still open

The SMPTE ST 431-1 standard sets a nominal 48 cd/m² (14 foot-lamberts) at the centre of a cinema screen, within ±10.2 cd/m², measured with a spot meter from the centre of the row nearest the middle of the seating. The last large public survey this research found is SMPTE's own Screen Brightness Committee survey of 125 US theaters in summer 1950, published in 1951; searches found no recent public one.

pub.smpte.orgjournal.smpte.org

Built with what exists

A spot luminance meter with an acceptance angle of 2° or less, as the standard requires, such as the Konica Minolta LS-150, which Konica Minolta says is widely used for cinema screens; DCP-o-matic, free and open-source software that makes files in the Digital Cinema Package (DCP) format cinemas play, for the white test picture; a shared spreadsheet for the results.

sensing.konicaminolta.asiadcpomatic.com

  1. First step

    Ask one independent cinema to play a white test picture made in DCP-o-matic before opening, and take the five readings from the reference seat.

  2. Done looks like

    At least 50 screens from at least 10 operators in at least three countries measured by the standard's method, each published with its centre reading, its four outer readings as a share of the centre, its light source, and whether it falls within 48 ± 10.2 cd/m².

Open 02 · the brief

Log how loud shows play

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

A public log of sound levels at 100 ordinary paid screenings in at least five cinema chains. From a central seat, a sound level meter logs A- and C-weighted levels every second through the trailers and the feature. It records levels only, never the sound itself, so nothing of the film is copied. Each screening is published with its trailer and feature averages, and the same film is measured in several cinemas.

Why it is still open

The per-film survey this research found, by David Ellerton (2002), measured 17 screenings of 14 films in London multiplexes, found the same soundtrack playing 7 to 9 dB louder or quieter (LAeq, an A-weighted average) from one cinema to another, and left trailers out. Robinson's 2025 SMPTE paper says the problems remain, and it is behind a member paywall; searches found no public per-screening dataset.

acoustics.org.nzjournal.smpte.org

Built with what exists

A Class 1 logging sound level meter, such as NTi Audio's XL2 analyzer, checked with an acoustic calibrator before each show; Python with pandas for per-minute and per-block averages; a public data repository.

  1. First step

    Calibrate one meter, log five screenings of the same film at five cinemas, and publish the five logs side by side.

  2. Done looks like

    100 screenings logged and published, at least 20 films each measured in two or more cinemas, the spread between cinemas for the same film given in dB, and each trailer block compared with the feature that follows it.