BRENNEN

Industries / Construction and property / Engineering and architecture / Geotechnical engineering

Ground improvement

Ground improvement makes weak ground stronger, denser or quicker to settle before anything is built on it, by draining, shaking, pounding, grouting or mixing it.

7

Milestones achieved, from 1926 to 1974.

1

To watch for: announced, not yet confirmed outside.

2

Open deliverables. Nobody has shipped them.

The road

AchievedWatch forOpen

Achieved

  1. 1926

    Sand columns drain clay

    Soft clay under a new embankment can settle for years while water slowly squeezes out of it, and vertical drains, columns of sand, shorten the distance the water must travel. D. J. Moran was granted a US patent for a sand drain system in 1926, and the California Division of Highways tested sand drains in the laboratory and the field from 1933; until the early 1980s they were almost the only vertical drain used on US highway projects.

    fhwa.dot.gov

    Credit

    D. J. Moran; California Division of Highways

  2. 1936

    Vibrating probes pack sand

    In Germany in the early 1930s engineers developed a metal probe with an electric motor turning an off-centre weight near its tip; jetted into loose sand with water, it shakes the grains into a denser packing. Patented as Vibroflotation, it was used to densify underwater sands for north German seaports, and by 1936 it could compact sand to about 18 m (60 ft). The first US job was at Cape May, New Jersey, in 1948, and by the early 1970s it was the leading way to densify deep sand.

    fhwa.dot.govkeller.com

    Credit

    engineers in Germany, by FHWA's account; Keller says it invented the vibro method in the 1930s

  3. 1960s

    Cement mixed into ground

    Deep mixing blends a binder such as cement or lime into soft soil where it lies, with rotating blades or cutting wheels, leaving columns, walls or blocks of soil-cement. FHWA dates its main development to Japan and Scandinavia from the 1960s. In the US it spread after Hurricane Katrina: one New Orleans levee, LPV 111, took about 1.7 million cubic yards (1.3 million m³) of soil-cement, and the FHWA published a deep mixing manual in 2013.

    fhwa.dot.gov

    Credit

    engineers in Japan and Scandinavia; in the US, the FHWA and the US Army Corps of Engineers

  4. 1969

    Dropping weights to compact

    Heavy tamping, dropping a weight of about 8 to 10 tonnes (18 to 22 kips) from about 8 to 12 m (25 to 40 ft) again and again, came into regular use in Europe in 1969 and in the US in 1971. L. Menard and Y. Broise's 1975 paper gave a formula for the depth improved as a function of the energy dropped, which the FHWA says put the method "on a sound technical basis".

    fhwa.dot.gov

    Credit

    L. Menard and Y. Broise

  5. 1972

    Plastic wick drains arrive

    In Sweden Walter Kjellman made a drain from three layers of cardboard about 10 cm (4 in.) wide, installed by machine; the FHWA dates it to the late 1930s and Massarsch and Fellenius to the early 1940s. The cardboard passed too little water and resisted pressure poorly, so Sweden went back to sand drains. Kjellman's colleague Oleg Wager kept working on it and in 1972 patented the Geodrain, a grooved plastic core wrapped in a paper filter, while Japan developed the similar Castleboard drain; such prefabricated drains reached the US in the mid-to-late 1970s.

    LessonThe idea worked before the material did; the wick drain needed a plastic core to replace sand drains.

    fhwa.dot.govfellenius.net

    Credit

    Walter Kjellman and Oleg Wager, Swedish Geotechnical Institute

  6. 1972

    Jetting grout into soil

    Jet grouting uses high-pressure, high-speed jets of water, air or grout to break up soil and mix it with cement grout, leaving columns of what is called soilcrete. The FHWA says it was developed in Japan in the early 1970s (Yahiro and Yoshida, 1972) from a British idea of the 1960s and spread to Europe from Italy in the mid-1970s. US demonstration projects in the early 1980s used ordinary drilling equipment and failed, and the method lay idle there until 1986, when it returned with purpose-built equipment; more than 200 US projects followed between 1988 and 1997.

    LessonThe early US failures came from the equipment, not the idea.

    fhwa.dot.gov

    Credit

    T. Yahiro and H. Yoshida

  7. 1974

    Chemical grout poisons water

    In Japan in 1974, cases of water poisoning were linked to acrylamide grout, a chemical injected into the ground to seal and strengthen it. Japan banned acrylamides at once, and later all chemical grouts except silicate-based ones without toxic additives; in the US the main maker of acrylamide grout withdrew it voluntarily in 1978.

    LessonWhat is injected into the ground can reach drinking water, so a grout has to be judged by what can leave the treated zone as well as by its strength.

    fhwa.dot.gov

    Credit

    the Japanese authorities, as the FHWA reports

Watch for

  1. Gas and calcite under dikes

    Engineers say microbially induced desaturation and precipitation (MIDP), in which bacteria already living in the sediment are fed a nutrient solution and make gas bubbles and calcite cement between the grains, could cut the risk that sands under the Fraser River dikes in British Columbia, Canada, liquefy in an earthquake. Their case rests on laboratory tests and numerical analysis, and they have planned a field pilot meant to bring the method to technology readiness level 6, "technology demonstrated in relevant environment"; the project stood at level 4, validated in the laboratory.

    Achieved whenthe pilot is run under a working dike and before-and-after tests by an independent party show that the gas and cement persist and that the ground resists liquefaction better.

    issmge.org

    Claimed by

    Y. Veenis (Groundwater Technology BV), E. Kavazanjian Jr. (Arizona State University), L. van Paassen (Boskalis) and colleagues, May 2025

Open

  1. 01

    Compaction results, pooled and open

    An open dataset of cone penetration tests (CPTs, in which a probe pushed into the ground records its resistance) taken before and after deep vibratory compaction or heavy tamping at the same spots, with the soil grading at each, and a published comparison of the measured gain against the soil types the methods are said to suit.

    The brief
    Credit · unclaimed
  2. 02

    A biocement round robin

    An interlaboratory comparison of biocement, sand cemented by microbially induced carbonate precipitation (MICP): one batch of sand and one written recipe for the bacteria and treatment solutions, used by five laboratories to make specimens, which each lab caps the same way and tests for unconfined compressive strength and calcium carbonate content.

    The brief
    Credit · unclaimed

Open 01 · the brief

Compaction results, pooled and open

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An open dataset of cone penetration tests (CPTs, in which a probe pushed into the ground records its resistance) taken before and after deep vibratory compaction or heavy tamping at the same spots, with the soil grading at each, and a published comparison of the measured gain against the soil types the methods are said to suit.

Why it is still open

Massarsch, Wersäll and Fellenius (2019) re-analysed five published case histories that had both CPTs and dilatometer tests before and after compaction, and noted that compaction case histories are usually based on one test method. A search found no open, pooled dataset of before-and-after soundings from compaction projects.

fellenius.net

Built with what exists

Open-access case histories in the ISSMGE online library; a curve digitizer such as WebPlotDigitizer for published plots; an AI model to pull site details out of papers; Python.

  1. First step

    Download ten open case histories from the ISSMGE library and digitize the before and after CPT curves from two of them.

  2. Done looks like

    100 before-and-after CPT pairs from at least 20 sites in at least five countries, released as open data files, with a published table of the median gain in cone resistance by fines content.

Open 02 · the brief

A biocement round robin

Credit · unclaimed

The first to publish is credited on this line, and the deliverable moves from Open to Achieved.

What to build

An interlaboratory comparison of biocement, sand cemented by microbially induced carbonate precipitation (MICP): one batch of sand and one written recipe for the bacteria and treatment solutions, used by five laboratories to make specimens, which each lab caps the same way and tests for unconfined compressive strength and calcium carbonate content.

Why it is still open

A 2025 study by Sang, El Mountassir, Minto and Lunn found "significant variability" among published links between biocement strength and carbonate content, and showed that the way specimen ends are capped, a step it says "has been largely overlooked", changes the measured strength. A search found no interlaboratory study of biocement strength.

strathprints.strath.ac.uk

Built with what exists

A standard silica sand; a bacterial culture and treatment solutions made to one recipe; gypsum plaster caps to ASTM C617, as the study recommends; an ordinary load frame; an acid-digestion test for carbonate content.

  1. First step

    Write a one-page recipe and testing protocol and send it to three laboratories whose authors presented at ICBBG 2025, the May 2025 biogeotechnics conference whose papers the ISSMGE hosts.

  2. Done looks like

    Five laboratories, at least ten specimens each, and a published table of every specimen's strength and carbonate content with the spread between laboratories.