Industries / Consumer goods / Consumer appliances
Motors and compressors
The motors that turn drums, fans and pumps, and the compressors and refrigerants that carry heat out of fridges and freezers.
6
Milestones achieved, from 1927 to 2020.
2
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
The road
AchievedWatch forOpen
Achieved
1927
A sealed compressor on top
In 1927 General Electric began selling a refrigerator with its compressor mounted on top of an all-steel cabinet. The public called it the "Monitor Top", after the gun turret of the Civil War warship USS Monitor. A hermetically sealed steel case, closed all round, covered the compressor coils, so no dust collected on them and the case could be scrubbed clean. The Albany Institute of History & Art, quoted by the trade magazine ACHR News, says it sold for about $525 at launch and for as little as $200 within a few years, and ACHR News calls it the first affordable refrigerator in the US. ASSEMBLY magazine reports that it took 7% of the US home refrigerator market in its first year and that GE went on to make more than a million.
Credit
General Electric; the Albany Institute credits GE's chief engineer Christian Steenstrup with the sealed case
1930
Fluorine refrigerants arrive
In May 1930 Thomas Midgley and Albert L. Henne published "Organic Fluorides as Refrigerants" in the journal Industrial & Engineering Chemistry. The chemicals that came out of this work, chlorofluorocarbons (CFCs, carbon compounds holding chlorine and fluorine), were "soon used as refrigerants" and in aerosol sprays, says a 2018 brochure from GIZ, the German government's development agency.
Credit
Thomas Midgley and Albert L. Henne
1987
Ozone-safe refrigerants required
In 1974 Mario Molina and F. Sherwood Rowland reported in Nature that chlorine from CFCs, once it reaches the stratosphere, destroys ozone. The Montreal Protocol, signed in 1987 and in force from 1989, set a phase-out of the production and consumption of ozone-depleting chemicals, CFC refrigerants among them. Makers moved to hydrofluorocarbons (HFCs), which spare the ozone layer but are strong greenhouse gases, so the Kigali Amendment of 2016 added a phase-down of HFCs. The UN's Ozone Secretariat says the ozone layer is "well on its way to recovery".
LessonA refrigerant chosen because it was safe in the kitchen did harm high in the atmosphere, and its first replacement then had to be cut back as well.
Credit
Mario Molina and F. Sherwood Rowland; the parties to the Montreal Protocol, with the UN Environment Programme's Ozone Secretariat
1993
Isobutane in the fridge
On 15 March 1993 the first "Greenfreeze" refrigerators came off the line at Foron, formerly DKK Scharfenstein, in eastern Germany. They used isobutane, a hydrocarbon gas, as the refrigerant, and a hydrocarbon to blow the insulation foam, so they held no ozone-depleting chemicals. Greenpeace had gathered 70,000 sales contracts within three weeks of the launch campaign, and Bosch, Siemens, Liebherr and Miele brought out their own hydrocarbon models that spring. GIZ, citing figures from a UN Environment Programme technical committee and Greenpeace, put hydrocarbons at about two-thirds of world production of household fridges and freezers by 2018. The US Environmental Protection Agency (EPA) listed isobutane as acceptable for new US household fridges in December 2011; its table rates the gas in the higher-flammability safety class (A3).
LessonMost of the industry had adopted the HFC refrigerant R134a, and a small maker with a campaign group showed that a flammable gas could replace it.
Credit
Foron, under its managing director Eberhard Günther, and Greenpeace, whose Greenfreeze campaign was led by Wolfgang Lohbeck
2015
Europe bans HFC fridges
From 1 January 2015 the EU's F-gas Regulation of 2014 banned the sale of household fridges and freezers that contain HFCs with a global warming potential of 150 or more. Global warming potential (GWP) compares the warming caused by a kilogram of a gas with that of a kilogram of carbon dioxide. The US EPA's table gives HFC-134a, the refrigerant most makers had adopted in place of CFCs, a GWP of 1,430, and isobutane a GWP of 3.
Credit
the European Parliament and the Council of the EU
2020
Linear compressors in court
LG said in 2014 that it had introduced a refrigerator with an "inverter linear compressor" in 2001. In it a magnet and springs drive the piston straight back and forth, instead of through a crank. LG claimed it was about 32% more energy efficient than conventional compressors and gave "a 20 year life-span", and it carried a 10-year warranty from 2009, according to LG statements quoted in a 2019 class action complaint in California. That complaint said the fridges were "failing en masse within 36 months". In 2020 LG settled a New Jersey class action covering about 1.55 million US buyers of models produced from 2014 to 2017: cash payments, a five-year warranty covering the full cost of repairing cooling failures, more technicians and better replacement parts. LG disputed the claims. An Ontario court approved a Canadian settlement on 27 May 2024.
LessonA compressor sold on efficiency and long life is tested in owners' kitchens, and here the dispute ended in longer warranties and extra repair staff, not a court finding that the part was defective.
Credit
LG Electronics (the compressor); owners' class actions in US and Canadian courts
Watch for
GaN chips drive appliance motors
Gallium nitride (GaN) transistors switch power with lower losses than silicon ones. STMicroelectronics launched its GANSPIN612 GaN motor driver in January 2026. It says the GANSPIN611 and GANSPIN612 need no heatsink at outputs where a silicon inverter needs one, above about 150 to 200 W, and it names fridge compressors and hair dryers as uses. Navitas Semiconductor says its GaNSense motor-drive chips, aimed at washing machines, dryers, dishwashers and refrigerators, give up to 4% higher efficiency, a 40% smaller circuit board and 15% lower system cost than "legacy silicon IGBT solutions", meaning drives built on the older silicon switch. ST also makes a 100 V GaN driver for robot joints (see the Note "A half-bridge in 6.5 by 5 mm").
Achieved whenan appliance on sale uses a GaN motor drive and an outside laboratory measures its energy use against the same model with a silicon drive.
Claimed by
STMicroelectronics, January and July 2026; Navitas Semiconductor, July 2025
AI-tuned compressor motors
Samsung says its "AI digital inverter compressors" use AI to adjust the compressor's motor "to help save energy and improve durability". It says its fridge compressors are tested by running for 1,500 hours at 85°C and 500 hours at 100°C, and that its eighth-generation compressor is machined to a tolerance of 5 μm (0.005 mm). It gives no figures for energy saved or failures avoided.
Achieved whenan outside laboratory publishes energy use and failure rates for fridges with and without the AI control.
Claimed by
Miyoung Yoo, head of the global customer service team for Samsung Electronics' appliance business, January 2026
Open
01
Phone recordings of failing appliances
An open set of phone recordings of household fridges, freezers, washing machines and dryers, made at repair events before and after each repair. Each recording is labeled with the model and the fault the repair found, such as a worn drum bearing, a failing fan, a blocked drain pump, worn motor brushes or a noisy compressor. Add a baseline model that names the likely faulty part from a 30-second clip, tested on brands it was not trained on.
The briefCredit · unclaimed02
A measured magnet census
A public table of the permanent magnets in motors taken from scrapped washing machines, dryers, dishwashers and vacuum cleaners: model, motor type, magnet material (rare-earth neodymium-iron-boron or ceramic ferrite) and magnet mass, all measured rather than estimated. Fridge compressors stay out, because they hold refrigerant that only licensed recyclers should remove.
The briefCredit · unclaimed
Open 01 · the brief
Phone recordings of failing appliances
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
An open set of phone recordings of household fridges, freezers, washing machines and dryers, made at repair events before and after each repair. Each recording is labeled with the model and the fault the repair found, such as a worn drum bearing, a failing fan, a blocked drain pump, worn motor brushes or a noisy compressor. Add a baseline model that names the likely faulty part from a 30-second clip, tested on brands it was not trained on.
Why it is still open
Public machine-sound sets cover factory machines. Hitachi's MIMII set (2019) holds valves, pumps, fans and slide rails. HAASD (Jiang and others, 2018) posted processed sound files of normal and abnormal washing machines on GitHub, labeled only normal or abnormal, with no fault types or raw audio. The closest appliance work, a 2022 Sabancı University thesis done with the Turkish appliance maker Arçelik, recorded fridge fan faults in an anechoic room (one with no echoes) and classified them with 89% accuracy; a 2022 paper from the UAE used compressor sound on the production line with statistical control charts. Neither recorded failing appliances in homes with phones, and no download of either set was found. A Zenodo search for refrigerator compressor sound found no such set.
research.sabanciuniv.eduresearch.uaeu.ac.aezenodo.orggithub.com
Built with what exists
Ordinary phones; repair cafés that already log faults under the Open Repair Data Standard; the open Audio Spectrogram Transformer model on Hugging Face (MIT/ast-finetuned-audioset-10-10-0.4593), fine-tuned on the clips; Zenodo for publishing.
First step
Ask one repair café or appliance repairer to record 30 seconds of every fridge and washing machine at its next session, before and after the fix, and to log the fault found.
Done looks like
At least 500 recordings from at least 150 appliances of 20 brands, each tied to a fault confirmed by the repair, published under an open license; a baseline whose accuracy and confusion table on held-out brands are published; and a second group that re-records 30 of the appliances to check the labels.
Open 02 · the brief
A measured magnet census
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public table of the permanent magnets in motors taken from scrapped washing machines, dryers, dishwashers and vacuum cleaners: model, motor type, magnet material (rare-earth neodymium-iron-boron or ceramic ferrite) and magnet mass, all measured rather than estimated. Fridge compressors stay out, because they hold refrigerant that only licensed recyclers should remove.
Why it is still open
A TU Delft master's thesis (April 2026) tore down one washing machine and ten cordless stick vacuums to map where critical raw materials sit. It estimated magnet content from the literature and reports "material uncertainty", noting that higher-priced models more often used brushless motors, which are more likely to hold rare-earth magnets. A 2011 Japanese study (Arai and others) estimated recoverable neodymium magnets from compressors and motors in appliances collected through Japan's recycling system, from model data. No measured, model-by-model table was found.
Built with what exists
Dead motors from e-waste recyclers and repair cafés; hand tools; a kitchen scale and calipers to work out each magnet's density, which differs sharply between the two materials; a handheld gaussmeter; a commercial laboratory analysis of a sample of magnets to check the sorting; phone photos of motor nameplates read with a vision model; a spreadsheet published on Zenodo.
First step
Ask one local e-waste recycler for ten dead washing machine and vacuum motors, take out the magnets, and weigh and measure them.
Done looks like
At least 200 motors from at least 25 brands and four appliance types, each with magnet material and mass recorded, 20 of them confirmed by an outside laboratory, published as open data.