Industries / Mining and materials / Steel and metals / Aluminum smelting
Emissions and waste
Emissions and waste covers what refineries and smelters leave behind: caustic red mud from refining, fluoride gases and perfluorocarbons from the smelting cells, worn-out cell linings, and the carbon dioxide counted against each tonne.
7
Milestones achieved, from 1896 to 2025.
2
To watch for: announced, not yet confirmed outside.
2
Open deliverables. Nobody has shipped them.
The road
AchievedWatch forOpen
Achieved
1896
Red mud with no use
At the Larne refinery in Northern Ireland, works manager James Sutherland said in 1896, "At present the red mud is useless," while experiments looked for a use. About two million tonnes went into a pond on the sloblands, the tidal mudflats beside the works. From December 1948, after alumina production stopped, some was dug out to make red oxide pigment and the rest was sold to a cement works, by Thierry Renaux's history.
Lessonthe residue problem arrived with the first Bayer plants and outlasted them.
Credit
British Aluminium Company, Larne
1959
Fluoride ruled a trespass
Oregon's Supreme Court upheld damages against Reynolds Metals, whose smelter near Troutdale had let fluoride gases and particles settle on the Martins' farm from 1951 to 1956. The couple said their cattle were poisoned by eating the contaminated forage. The trial court had awarded $71,500 for the lost use of the land and $20,000 for its deterioration, and the court held that depositing the chemicals was a trespass, so the company was liable whether or not it had been careless.
Lessonfluoride that leaves a smelter is a cost the smelter carries.
Credit
Oregon Supreme Court, in Martin v. Reynolds Metals Co
2008
Pot lining made safe
Spent pot lining is the worn carbon and brick lining of a smelting cell. It holds fluorides and cyanides and gives off hydrogen, methane and ammonia when wet; Rio Tinto researchers estimate that more than half of what is made each year is stockpiled or landfilled. Rio Tinto opened a plant at Jonquière, Québec, in April 2008 that leaches out the fluorides, destroys the cyanides and leaves inert products that cement makers use. It reached its rated 80,000 tonnes a year only in 2014, and it now treats all the pot lining Rio Tinto makes in Canada.
Lessona new waste plant took six years to reach its rated output.
Credit
Rio Tinto's Arvida Research and Development Centre
2010
Ajka residue flood
In October 2010 a reservoir of red mud at the Ajka alumina plant in western Hungary failed. Between 0.8 and 1 million cubic meters of caustic slurry, at pH 12 to 13, flooded about 40 km² of farmland, wetland and villages; ten people died, more than a hundred were injured, and the mud reached the Danube 120 km downstream.
Lessonresidue stored wet behind an embankment can travel far and kill when the wall gives way.
Credit
Ajkai Timfoldgyar Zrt, the plant's operator
2014
Air samples expose missing PFCs
Perfluorocarbons (PFCs) such as tetrafluoromethane (CF4) are greenhouse gases that last for thousands of years, released mainly during anode effects, upsets in a smelting cell when too little alumina is dissolved. Using measurements from the AGAGE air-monitoring network, Jooil Kim and colleagues found world emissions well above what industry and national inventories reported, and traced part of the gap to China's aluminum industry after 2002. In 2019 the IPCC's revised inventory guidelines added "low voltage" anode effects, which release CF4 without the voltage spike smelters counted and had been left out of national inventories.
Lessoninventories built from smelter records can miss emissions that measurements of the air catch.
Credit
Jooil Kim and colleagues; the IPCC Task Force on National Greenhouse Gas Inventories
2016
EU sets fluoride limits
The European Commission's best available techniques conclusions for non-ferrous metals, adopted on 13 June 2016, are the reference for EU smelter permits. For cell gas they name a dry scrubber using alumina followed by a bag filter, and they set total fluoride from a potroom at no more than 0.6 kg per tonne of aluminum for existing plants and 0.35 kg for new ones. In a dry scrubber the alumina soaks up the fluoride and is then fed to the cells, so the fluoride goes back into the bath; REEL, which builds these gas treatment centers, says they have been in use for about 50 years. The same text tells refineries to press residue into a semi-dry cake.
Credit
European Commission
2025
China prices smelter PFCs
China's Ministry of Ecology and Environment released a work plan on 20 March 2025 that brought aluminum smelting, steel and cement into the national emissions trading system. For smelters it covers CF4 and hexafluoroethane (C2F6) as well as carbon dioxide. The first deadline to surrender allowances was the end of 2025, for 2024 emissions, with free allowances equal to verified emissions; for 2025 and 2026 allowances depend on output and emissions per tonne.
Credit
China's Ministry of Ecology and Environment
Watch for
Red mud stripped of iron
FAST Metals, a US start-up, says its patented process removes iron from red mud and leaves a material from which gallium, alumina, titania and rare earth elements can be recovered. It announced a first commercial customer, Metalox, at whose Florida plant it will treat one ton a week of red mud and other iron-bearing waste, and said this confirms commercial viability.
Achieved whenan outside party publishes recovery rates and the cut in residue volume from a sustained run, or a refinery contracts the process at thousands of tonnes a year.
Claimed by
FAST Metals, July 2026
Smelter map for CF4
Zach Dissington, an independent researcher, posted an open registry of 94 primary aluminum smelters in 36 countries and a map of where CF4 should come from, for use in inversions, studies that work back from measured air concentrations and winds to where emissions came from. He reports that over Iceland the map matches European CF4 estimates from air measurements better than the EDGAR inventory (a correlation of 0.25 against 0.00), which assigns no CF4 to 15 of 22 European smelter grid cells. The paper is a preprint, open for discussion since 6 October 2026.
Achieved whenthe paper passes review and an independent inversion team reports that the map improves its CF4 estimates.
Claimed by
Zach Dissington, October 2026
Open
01
Satellite map of residue areas
A public map of every bauxite residue storage area in the world, outlined from satellite images, with its area each year since 2017 and the ground movement measured by radar satellites.
The briefCredit · unclaimed02
Register of spent pot lining
A public register giving, for each smelter, how much spent pot lining it makes each year, how much it holds in store, and where the rest goes (landfill, treatment plant or cement kiln), every figure linked to its source.
The briefCredit · unclaimed
Open 01 · the brief
Satellite map of residue areas
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public map of every bauxite residue storage area in the world, outlined from satellite images, with its area each year since 2017 and the ground movement measured by radar satellites.
Why it is still open
Refineries have stored more than 2.7 billion tonnes of residue, and only 2 to 3% of the roughly 150 million tonnes made each year is put to use, by Ujaczki and colleagues. The Global Tailings Portal holds data on more than 1,800 mine tailings dams disclosed by about 100 listed mining companies and does not mention bauxite residue. The closest satellite studies found map single sites, such as the waste at one inactive bauxite mine in Greece studied by Kouzeli and colleagues in 2025.
pmc.ncbi.nlm.nih.govtailing.grida.noisprs-archives.copernicus.org
Built with what exists
Sentinel-2 optical and Sentinel-1 radar images, free from the EU's Copernicus program; Google Earth Engine; open radar interferometry (InSAR) processing, which measures ground movement to millimeters from repeated radar passes, such as the Alaska Satellite Facility's HyP3 service; refinery locations from the USGS Minerals Yearbook.
First step
Outline the residue areas of five refineries on 2025 Sentinel-2 images and compare them with the companies' own figures.
Done looks like
Outlines for the residue areas of at least 60 operating refineries, the area of each for every year from 2017 to 2026, ground movement maps for at least 20, and outlines checked against areas companies publish for at least 10 sites.
Open 02 · the brief
Register of spent pot lining
The first to publish is credited on this line, and the deliverable moves from Open to Achieved.
What to build
A public register giving, for each smelter, how much spent pot lining it makes each year, how much it holds in store, and where the rest goes (landfill, treatment plant or cement kiln), every figure linked to its source.
Why it is still open
About 1.45 million tonnes were made in 2020, by the IAI count quoted by Rio Tinto researchers, who estimate that more than half is stockpiled or landfilled; no smelter-by-smelter figures are given. Even single sites revise their counts: in 2021 New Zealand's Tiwai Point smelter raised its estimate of stored lining from 181,000 to about 217,000 tonnes after an audit. A search found no public register by smelter.
Built with what exists
Smelter sustainability reports and permits; US EPA hazardous waste reports, in which spent potliner carries the waste code K088; the EU's Industrial Emissions Portal for waste transfers; Python; an AI model to draft entries from documents for a person to check (see the Note "Seven more flagged").
First step
Pull the K088 records for US smelters and the pot lining figures in five smelter sustainability reports.
Done looks like
At least 50 smelters with three years of figures each, every number sourced and checked by two people, and the total compared with the IAI's world figure.